Vesel Alenka, Zaplotnik Rok, Primc Gregor, Mozetič Miran
Jozef Stefan Institute, Department of Surface Engineering, Jamova cesta 39, 1000 Ljubljana, Slovenia.
Polymers (Basel). 2024 May 12;16(10):1381. doi: 10.3390/polym16101381.
The wettability of polymers is usually inadequate to ensure the appropriate spreading of polar liquids and thus enable the required adhesion of coatings. A standard ecologically benign method for increasing the polymer wettability is a brief treatment with a non-equilibrium plasma rich in reactive oxygen species and predominantly neutral oxygen atoms in the ground electronic state. The evolution of the surface wettability of selected aromatic polymers was investigated by water droplet contact angles deposited immediately after exposing polymer samples to fluxes of oxygen atoms between 3 × 10 and 1 × 10 ms. The treatment time varied between 0.01 and 1000 s. The wettability evolution versus the O-atom fluence for all aromatic polymers followed similar behavior regardless of the flux of O atoms or the type of polymer. In the range of fluences between approximately 5 × 10 and 5 × 10 m, the water contact angle decreased exponentially with increasing fluence and dropped to 1/e of the initial value after receiving the fluence close to 5 × 10 m.
聚合物的润湿性通常不足以确保极性液体的适当铺展,从而无法实现涂层所需的附着力。一种提高聚合物润湿性的标准生态友好方法是用富含活性氧物种且主要是基态电子态中性氧原子的非平衡等离子体进行短暂处理。通过在将聚合物样品暴露于3×10至1×10毫秒的氧原子通量后立即沉积的水滴接触角,研究了所选芳香族聚合物表面润湿性的演变。处理时间在0.01至1000秒之间变化。无论氧原子通量或聚合物类型如何,所有芳香族聚合物的润湿性演变与氧原子通量的关系都遵循相似的行为。在大约5×10至5×10米的通量范围内,水接触角随通量增加呈指数下降,在接收到接近5×10米的通量后降至初始值的1/e。