Mori Takuya, Matsushita Satoshi, Morita Terumasa, Abudurezake Abulaiti, Mochizuki Junji, Amano Atsushi
Department of Cardiovascular Surgery, Juntendo University Faculty of Medicine, Tokyo 113-8421, Japan.
Department of Cardiovascular Surgery, JACCT Japan Animal Cardiovascular Care Team, Osaka 533-0033, Japan.
World J Cardiol. 2024 May 26;16(5):274-281. doi: 10.4330/wjc.v16.i5.274.
Mitral valvuloplasty using artificial chordae tendineae represents an effective surgical approach for treating mitral regurgitation. Achieving precise measurements of artificial chordae tendineae length (CL) is an important factor in the procedure; however, no objective index currently exists to facilitate this measurement. Therefore, preoperative assessment of CL is critical for surgical planning and support. Four-dimensional x-ray micro-computed tomography (4D-CT) may be useful for accurate CL measurement considering that it allows for dynamic three-dimensional (3D) evaluation compared to that with transthoracic echocardiography, a conventional inspection method.
To investigate the behavior and length of mitral chordae tendineae during systole using 4D-CT.
Eleven adults aged > 70 years without mitral valve disease were evaluated. A 64-slice CT scanner was used to capture 20 phases in the cardiac cycle in electrocardiographic synchronization. The length of the primary chordae tendineae was measured from early systole to early diastole using the 3D image. The primary chordae tendineae originating from the anterior papillary muscle and attached to the A1-2 region and those from the posterior papillary muscle and attached to the A2-3 region were designated as cA and cP, respectively. The behavior and maximum lengths [cA (ma), cP (max)] were compared, and the correlation with body surface area (BSA) was evaluated.
In all cases, the mitral anterior leaflet chordae tendineae could be measured. In most cases, the cA and cP chordae tendineae could be measured visually. The mean cA (max) and cP (max) were 20.2 mm ± 1.95 mm and 23.5 mm ± 4.06 mm, respectively. cP (max) was significantly longer. The correlation coefficients (r) with BSA were 0.60 and 0.78 for cA (max) and cP (max), respectively. Both cA and cP exhibited constant variation in CL during systole, with a maximum 1.16-fold increase in cA and a 1.23-fold increase in cP from early to mid-systole. For cP, CL reached a plateau at 15% and remained elongated until end-systole, whereas for cA, after peaking at 15%, CL shortened slightly and then moved toward its peak again as end-systole approached.
The study suggests that 4D-CT is a valuable tool for accurate measurement of both the length and behavior of chordae tendineae within the anterior leaflet of the mitral valve.
使用人工腱索进行二尖瓣成形术是治疗二尖瓣反流的一种有效手术方法。实现人工腱索长度(CL)的精确测量是该手术的一个重要因素;然而,目前尚无客观指标来辅助这一测量。因此,术前对CL的评估对于手术规划和支持至关重要。考虑到与传统检查方法经胸超声心动图相比,四维X射线微计算机断层扫描(4D-CT)能够进行动态三维(3D)评估,其可能有助于准确测量CL。
使用4D-CT研究二尖瓣腱索在收缩期的行为和长度。
对11名年龄大于70岁且无二尖瓣疾病的成年人进行评估。使用64层CT扫描仪在心电图同步下采集心动周期中的20个相位。使用三维图像测量从收缩早期到舒张早期的主要腱索长度。源自前乳头肌并附着于A1-2区域的主要腱索以及源自后乳头肌并附着于A2-3区域的主要腱索分别指定为cA和cP。比较其行为和最大长度[cA(最大值),cP(最大值)],并评估与体表面积(BSA)的相关性。
在所有病例中,二尖瓣前叶腱索均可测量。在大多数病例中,cA和cP腱索可通过视觉测量。cA(最大值)和cP(最大值)的平均值分别为20.2毫米±1.95毫米和23.5毫米±4.06毫米。cP(最大值)明显更长。cA(最大值)和cP(最大值)与BSA的相关系数(r)分别为0.60和0.78。cA和cP在收缩期的CL均呈现恒定变化,从收缩早期到中期,cA的CL最大增加1.16倍,cP的CL最大增加1.23倍。对于cP,CL在15%时达到平台期,并一直延长至收缩末期,而对于cA,在15%达到峰值后,CL略有缩短,然后在接近收缩末期时再次向峰值移动。
该研究表明,4D-CT是准确测量二尖瓣前叶内腱索长度和行为的有价值工具。