Rudling M J, Peterson C O
Biochim Biophys Acta. 1985 Mar 6;833(3):359-65. doi: 10.1016/0005-2760(85)90091-8.
A convenient binding assay has been developed for the determination of low-density lipoprotein (LDL) receptors in homogenates of cultured and freshly-isolated normal and malignant human cells. Cell homogenates were incubated with 125I-labeled LDL and the ligand bound to the homogenate particulates was separated from the unbound ligand by filtration. When the particulates of the homogenates were subsequently incubated with heparin, a fraction of the bound 125I-LDL was released. Previous studies on intact cells have shown that heparin exclusively releases LDL bound to its cell surface receptor. The heparin-sensitive binding of 125I-LDL to cell homogenate particulates represents LDL bound to its cell surface receptor as judged from the following criteria: (a) it was quantitatively similar to the heparin-sensitive binding of 125I-LDL to intact cells, (b) it showed a direct correlation to the receptor-mediated degradation of 125I-LDL by intact cells, (c) no heparin-sensitive binding could be detected in homogenates prepared from normal erythrocytes or from cultured fibroblasts from a patient with homozygous familial hypercholesterolemia (two types of cell lacking LDL receptors), (d) it was dependent on calcium and inhibited by EDTA, (e) it was susceptible to treatment with pronase, and (f) it was heat-labile. The assay developed should be of value in determining the number of LDL receptors in tissues, since it is far less time-consuming and requires less material than currently available methods.
已开发出一种简便的结合测定法,用于测定培养的和新鲜分离的正常及恶性人细胞匀浆中的低密度脂蛋白(LDL)受体。将细胞匀浆与125I标记的LDL一起孵育,然后通过过滤将与匀浆颗粒结合的配体与未结合的配体分离。当匀浆颗粒随后与肝素一起孵育时,一部分结合的125I-LDL会被释放出来。先前对完整细胞的研究表明,肝素专门释放与其细胞表面受体结合的LDL。从以下标准判断,125I-LDL与细胞匀浆颗粒的肝素敏感结合代表与其细胞表面受体结合的LDL:(a)它在数量上与125I-LDL与完整细胞的肝素敏感结合相似,(b)它与完整细胞对125I-LDL的受体介导降解呈直接相关,(c)在由正常红细胞或纯合子家族性高胆固醇血症患者的培养成纤维细胞制备的匀浆中未检测到肝素敏感结合(这两种细胞类型缺乏LDL受体),(d)它依赖于钙并被EDTA抑制,(e)它易受链霉蛋白酶处理的影响,并且(f)它对热不稳定。所开发的测定法在确定组织中LDL受体数量方面应具有价值,因为与目前可用的方法相比,它耗时少得多且所需材料少。