Launay Manon, Ollier Edouard, Kably Benjamin, Le Louedec Félicien, Thiery Guillaume, Lanoiselée Julien, Perinel-Ragey Sophie
Medical Intensive Care Unit, University Hospital of Saint-Etienne, 42000 Saint Etienne, France.
Pharmacovigilance Department, University Hospital of Saint-Etienne, 42000 Saint Etienne, France.
Antibiotics (Basel). 2024 Aug 11;13(8):756. doi: 10.3390/antibiotics13080756.
To rapidly achieve ceftazidime target concentrations, a 2 g loading dose (LD) is recommended before continuous infusion, but its adequacy in critically ill patients, given their unique pharmacokinetics, needs investigation. This study included patients from six ICUs in Saint-Etienne and Paris, France, who received continuous ceftazidime infusion with plasma concentration measurements. Using MONOLIX and R, a pharmacokinetic (PK) model was developed, and the literature on ICU patient PK models was reviewed. Simulations calculated the LD needed to reach a 60 mg/L target concentration and assessed ceftazidime exposure for various regimens. Among 86 patients with 223 samples, ceftazidime PK was best described by a one-compartment model with glomerular filtration rate explaining clearance variability. Typical clearance and volume of distribution were 4.45 L/h and 88 L, respectively. The literature median volume of distribution was 37.2 L. Simulations indicated that an LD higher than 2 g was needed to achieve 60 mg/L in 80% of patients, with a median LD of 4.9 g. Our model showed a 4 g LD followed by 6 g/day infusion reached effective concentrations within 1 h, while a 2 g LD caused an 18 h delay in achieving target steady state.
为了快速达到头孢他啶的目标浓度,建议在持续输注前给予2g负荷剂量(LD),但鉴于重症患者独特的药代动力学特点,其是否充分仍需研究。本研究纳入了法国圣艾蒂安和巴黎6个重症监护病房(ICU)的患者,这些患者接受了头孢他啶持续输注并进行了血药浓度测定。使用MONOLIX和R软件建立了药代动力学(PK)模型,并对ICU患者PK模型的相关文献进行了综述。模拟计算了达到60mg/L目标浓度所需的负荷剂量,并评估了不同给药方案下头孢他啶的暴露情况。在86例患者的223份样本中,头孢他啶的PK最好用单室模型描述,肾小球滤过率可解释清除率的变异性。典型清除率和分布容积分别为4.45L/h和88L。文献报道的分布容积中位数为37.2L。模拟结果表明,80%的患者需要高于2g的负荷剂量才能达到60mg/L,负荷剂量中位数为4.9g。我们的模型显示,4g负荷剂量后每天输注6g,1小时内即可达到有效浓度,而2g负荷剂量则会导致达到目标稳态延迟18小时。