Suppr超能文献

临床 X 射线中新型 EBT4 光致变色胶片的系统特性描述。

Systematic characterization of new EBT4 radiochromic films in clinical x-ray beams.

机构信息

Medical Physics Program, Department of Physics and Astronomy, Howard University, Washington, DC, United States of America.

School of Medicine, University of Maryland, Baltimore, MD, United States of America.

出版信息

Biomed Phys Eng Express. 2024 Nov 6;11(1). doi: 10.1088/2057-1976/ad8c49.

Abstract

. We aim to characterize kinetics of radiation-induced optical density in newly released EBT4 radiochromic films exposed to clinical x-rays. Several film models and batches were evaluated for the film sensitivity, optical signal increasing with time, relative film noise, and minimum detectable limits (MDL).. Radiochromic film pieces from a single batch of EBT3 and three batches of EBT4 were exposed to doses of 77.38 cGy, 386.92 cGy, and 773.84 cGy using a 6 MV x-ray beam. The films were scanned with a flatbed scanner at specific time intervals up to 120 h. The time-series net optical density of red, green and blue colors was corrected for response of the scanner with time and studied to establish the saturation characteristics of film polymerization process. Dose-response from 3.86 cGy to 1935 cGy was also determined for each color. MDL of the films was quantitatively defined as the dose that would double the net optical density of red color above the standard deviation of the residual signal at zero dose. The relative noise characteristics of EBT3 versus EBT4 were studied as a function of time, dose and scanner resolution.. For doses ≥ 100 cGy, analysis revealed a stability of optical density beyond 48 h post-exposure for EBT3 and EBT4 films. EBT3 films attained 80%-90% of their net optical density at 48 h within minutes of irradiation, compared to 72%-88% for EBT4 films. The rate of growth was slowest for blue color, fastest for red, while green was in between the two. The MDL for EBT4 averaged 15 cGy for three batches, whereas EBT3 films reliably detected doses as low as 8.5 cGy.. Several batches of the new EBT4 film showed slightly lower response compared to its predecessor over 3.86 cGy to 1935 Gy range. For all practical purposes, the post-irradiation growth of polymers ceases between 48 to 60 h for both EBT films. Overall, the EBT4 film exhibited noise characteristics similar to EBT3, except for lower doses where the noise was observed to be higher than its predecessor.

摘要

. 我们旨在描述新发布的 EBT4 光致变色胶片在暴露于临床 X 射线时的辐射诱导光密度动力学。评估了几种胶片模型和批次的胶片灵敏度、随时间增加的光学信号、相对胶片噪声和最小可检测限 (MDL)。. 使用 6 MV X 射线束,将来自单个 EBT3 批次和三个 EBT4 批次的光致变色胶片曝光于 77.38 cGy、386.92 cGy 和 773.84 cGy 的剂量下。在特定时间间隔内,使用平板扫描仪扫描胶片,最长可达 120 小时。用时间校正红色、绿色和蓝色的时间序列净光密度,并对其进行研究,以建立胶片聚合过程的饱和特性。还为每种颜色确定了从 3.86 cGy 到 1935 cGy 的剂量响应。用时间、剂量和扫描仪分辨率作为函数,研究了 EBT3 与 EBT4 的相对噪声特性。. 对于剂量≥100 cGy,分析表明 EBT3 和 EBT4 胶片在曝光后 48 小时以上,其光密度保持稳定。EBT3 胶片在辐照后几分钟内达到其净光密度的 80%-90%,而 EBT4 胶片则达到 72%-88%。蓝色的增长速度最慢,红色的最快,而绿色则介于两者之间。EBT4 的 MDL 平均值为三个批次的 15 cGy,而 EBT3 胶片可靠地检测到低至 8.5 cGy 的剂量。. 与前一代相比,新的 EBT4 胶片在 3.86 cGy 到 1935 Gy 范围内,几个批次的响应略低。对于所有实际目的,EBT 胶片的聚合物在辐照后 48 至 60 小时之间停止生长。总体而言,EBT4 胶片的噪声特性与 EBT3 相似,除了在较低剂量下,其噪声高于前一代。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验