Buser Gianni
University of Basel, Department of Physics, Klingelbergstrasse 82, 4056 Basel, Switzerland.
Rev Sci Instrum. 2024 Dec 1;95(12). doi: 10.1063/5.0230870.
A series of simple and low-cost devices for switching, amplifying, and chirping diode lasers based on current modulation are presented. Direct modulation of diode laser currents is rarely sufficient to establish precise amplitude and phase control over light, as its effects on these parameters are not independent. These devices overcome this limitation by exploiting amplifier saturation and dramatically outperform commonly used external modulators in key figures of merit for quantum technological applications. Semiconductor optical amplifiers operated on either rubidium D line are recast as intensity switches and shown to achieve ON:OFF ratios >106 in as little as 50 ns. Current is switched to a 795 nm wavelength (Rb D1) tapered amplifier to produce optical pulses of few nanosecond duration and peak powers of 3 W at a similar extinction ratio. Fast rf pulses are applied directly to a laser diode to shift its emission frequency by up to 300 MHz in either direction and at a maximum chirp rate of 150 MHz ns-1. Finally, the latter components are combined, yielding a system that produces watt-level optical pulses with arbitrary frequency chirps in the given range and <2% residual intensity variation, all within 65 ns upon asynchronous demand. Such systems have broad application in atomic, molecular, and optical physics and are of particular interest to fast experiments simultaneously requiring high power and low noise, for example, quantum memory experiments with atomic vapors.
