Macgregor R B, Clegg R M, Jovin T M
Biochemistry. 1985 Sep 24;24(20):5503-10. doi: 10.1021/bi00341a034.
Pressure-jump chemical relaxation has been used to investigate the kinetics of ethidium bromide binding to the synthetic double-stranded polymers poly[d(G-C)] and poly[d(A-T)] in 0.1 M NaCl, 10 mM tris(hydroxymethyl)aminomethane hydrochloride, and 1 mM ethylenediaminetetraacetic acid, pH 7.2, at 24 degrees C. The progress of the reaction was followed by monitoring the fluorescence of the intercalated ethidium at wavelengths greater than 610 nm upon excitation at 545 nm. The concentration of DNA was varied from 1 to 45 microM and the ethidium bromide concentration from 0.5 to 25 microM. The data for both polymers were consistent with a single-step bimolecular association of ethidium bromide with a DNA binding site. The necessity of a proper definition of the ethidium bromide binding site is discussed: it is shown that an account of the statistically excluded binding phenomenon must be included in any adequate representation of the kinetic data. For poly[d(A-T)], the bimolecular association rate constant is k1 = 17 X 10(6) M-1 s-1, and the dissociation rate constant is k-1 = 10 s-1; in the case of poly[d(G-C)], k1 = 13 X 10(6) M-1 s-1, and k-1 = 30 s-1. From the analysis of the kinetic amplitudes, the molar volume change, delta V0, of the intercalation was calculated. In the case of poly[d(A-T)], delta V0 = -15 mL/mol, and for poly[d(G-C)], delta V0 = -9 mL/mol; that is, for both polymers, intercalation is favored as the pressure is increased.(ABSTRACT TRUNCATED AT 250 WORDS)
压力跃变化学弛豫法已被用于研究在24℃、pH 7.2的0.1M氯化钠、10mM三(羟甲基)氨基甲烷盐酸盐和1mM乙二胺四乙酸中,溴化乙锭与合成双链聚合物聚[d(G-C)]和聚[d(A-T)]结合的动力学。通过监测在545nm激发下,大于610nm波长处插入溴化乙锭的荧光来跟踪反应进程。DNA浓度在1至45μM之间变化,溴化乙锭浓度在0.5至25μM之间变化。两种聚合物的数据都与溴化乙锭与DNA结合位点的单步双分子缔合一致。讨论了正确定义溴化乙锭结合位点的必要性:结果表明,在动力学数据的任何适当表示中都必须考虑统计上排除的结合现象。对于聚[d(A-T)],双分子缔合速率常数为k1 = 17×10⁶M⁻¹s⁻¹,解离速率常数为k⁻¹ = 10s⁻¹;对于聚[d(G-C)],k1 = 13×10⁶M⁻¹s⁻¹,k⁻¹ = 30s⁻¹。通过对动力学振幅的分析,计算了插入的摩尔体积变化ΔV₀。对于聚[d(A-T)],ΔV₀ = -15mL/mol,对于聚[d(G-C)],ΔV₀ = -9mL/mol;也就是说,对于这两种聚合物,随着压力增加,插入作用更有利。(摘要截短于250字)