Yuan Yuhong, Xiao Jihong, Liu Shaoyan, He Tianyou, Rong Jundong, Zheng Yushan
Department of Economic Management, Fujian Forestry Vocational and Technical College, Nanping 353000, China.
College of Landscape Architecture and Art, Fujian Agriculture and Forestry University, Fuzhou 350002, China.
Biology (Basel). 2025 Aug 21;14(8):1104. doi: 10.3390/biology14081104.
is a medicinal and ornamental herbaceous plant with significant economic value, as its tuberous roots are used for medicinal purposes. However, the current production of medicinal plants is characterized by wasteful use of resources and ecological risks caused by the unreasonable application of nitrogen fertilizers. In this study, based on uniform application of phosphorus and potassium fertilizers, six nitrogen application levels were set in pot experiments (expressed as N): N0: 0 kg/ha, N1: 208.33 kg/ha, N2: 416.66 kg/ha, N3: 625 kg/ha, N4: 833.33 kg/ha, N5: 1041.66 kg/ha). The morphological characteristics, photosynthetic physiology, tuber yield and quality, and seven nitrogen fertilizer utilization indices of were analyzed and measured. Correlation analysis and structural equation modeling (SEM) were employed to investigate the mechanism by which nitrogen influences its growth and development, photosynthetic characteristics, tuber yield and quality, and nitrogen fertilizer utilization efficiency. The results showed that (1) nitrogen significantly promoted plant height, crown width, tiller number, and chlorophyll synthesis, with the N3 treatment (625 kg/ha) reaching the peak value, and the crown width and tiller number increasing by 26.44% and 38.90% compared to N0; the total chlorophyll content and net photosynthetic rate increased by 39.67% and 77.04%, respectively, compared to N0; high nitrogen (N5) inhibited photosynthesis and increased intercellular CO concentration; (2) Fresh weight of tuberous roots, polysaccharide content, and saponin C content peaked at N3 (34.67 g/plant, 39.89%, and 0.21%), respectively, representing increases of 128.69%, 28.37%, and 33.66% compared to N0; (3) Nitrogen uptake, nitrogen fertilizer utilization efficiency, agronomic utilization efficiency, and apparent utilization efficiency were optimal at N3, while high nitrogen (N4-N5) reduced nitrogen fertilizer efficiency by 40-60%; (4) SEM analysis indicated that tiller number and transpiration rate directly drive yield, while stomatal conductance regulates saponin C synthesis. Under the experimental conditions, 625 kg/ha is the optimal nitrogen application rate balancing yield, quality, and nitrogen efficiency. Excessive nitrogen application (>833 kg/ha) induces photosynthetic inhibition and "luxury absorption", leading to source-sink imbalance and reduced accumulation of secondary metabolites. This study provides a theoretical basis and technical support for the precise management of nitrogen in Liriope-type medicinal plants. It is expected to alleviate the contradictions of "high input, low output, and heavy pollution" in traditional fertilization models.
是一种具有重要经济价值的药用和观赏草本植物,其块根用于药用。然而,目前药用植物的生产存在资源浪费和氮肥不合理施用导致的生态风险问题。在本研究中,基于磷钾肥均匀施用的基础上,在盆栽试验中设置了六个施氮水平(以N表示):N0:0 kg/ha,N1:208.33 kg/ha,N2:416.66 kg/ha,N3:625 kg/ha,N4:833.33 kg/ha,N5:1041.66 kg/ha。分析测定了其形态特征、光合生理、块根产量和品质以及七个氮肥利用指标。采用相关性分析和结构方程模型(SEM)研究氮影响其生长发育、光合特性、块根产量和品质以及氮肥利用效率的机制。结果表明:(1)氮显著促进株高、冠幅、分蘖数和叶绿素合成,N3处理(625 kg/ha)达到峰值,冠幅和分蘖数相比N0分别增加26.44%和38.90%;总叶绿素含量和净光合速率相比N0分别增加39.67%和77.04%;高氮(N5)抑制光合作用并增加胞间CO浓度;(2)块根鲜重、多糖含量和皂苷C含量分别在N3处理时达到峰值(34.67 g/株、39.89%和0.21%),相比N0分别增加128.69%、28.37%和33.66%;(3)氮吸收、氮肥利用效率、农学利用效率和表观利用效率在N3时最佳,而高氮(N4 - N5)使氮肥效率降低40 - 60%;(4)SEM分析表明分蘖数和蒸腾速率直接驱动产量,而气孔导度调节皂苷C合成。在试验条件下,625 kg/ha是平衡产量、品质和氮效率的最佳施氮量。过量施氮(>833 kg/ha)会诱导光合抑制和“奢侈吸收”,导致源库失衡并减少次生代谢产物的积累。本研究为麦冬类药用植物氮素精准管理提供了理论依据和技术支持。有望缓解传统施肥模式中“高投入、低产出、重污染”的矛盾。