Forrester J S, Diamond G, Parmley W W, Swan H J
J Clin Invest. 1972 Mar;51(3):598-603. doi: 10.1172/JCI106849.
The left ventricular (LV) pressure-volume (P-V) relationship is a resultant of several determinants, including initial ventricular volume, geometry, and wall stiffness. A quantitative index of one of these determinants, LV wall stiffness, was developed from a mathematical analysis of the isolated P-V relationship. Since this relationship was exponential, stiffness (dP/dV) could be expressed by the equation dP/dV = aP + b, where a and b are constants. The a constant, termed the passive elastic modulus, was independent of both pressure and volume, was modified only slightly by changes in geometry, and thus was primarily affected by changes in wall stiffness. LV wall stiffness was assessed by determination of the passive elastic modulus in eight normal canine hearts and in five hearts 1 hr after acute myocardial infarction. The value of the passive elastic modulus for the normal canine LV was found to be 0.099+/-0.006 cc(-1). In the five infarcted hearts there was a modest, but statistically insignificant, shift of the P-V curves from control, such that for the same pressure the infarcted hearts contained greater volume. However, the passive elastic modulus decreased 41% to 0.057+/-0.006 cc(-1) (P < 0.001). Thus, although LV wall stiffness may increase later in the course of myocardial infarction, it is concluded that it was significantly decreased 1 hr after infarction. Calculation of the passive elastic modulus provided a sensitive means of detecting such changes, whereas P-V curves alone were generally insensitive.
左心室(LV)压力-容积(P-V)关系是多种决定因素共同作用的结果,这些因素包括初始心室容积、几何形状和室壁僵硬度。其中一个决定因素——左心室壁僵硬度的定量指标,是通过对孤立的P-V关系进行数学分析得出的。由于这种关系呈指数形式,僵硬度(dP/dV)可以用方程dP/dV = aP + b来表示,其中a和b是常数。常数a,即被动弹性模量,与压力和容积均无关,仅随几何形状的改变而略有变化,因此主要受室壁僵硬度变化的影响。通过测定8个正常犬心脏以及5个急性心肌梗死后1小时的心脏的被动弹性模量,来评估左心室壁僵硬度。正常犬左心室的被动弹性模量值为0.099±0.006 cc⁻¹。在5个梗死心脏中,P-V曲线相对于对照组有适度但无统计学意义的偏移,即在相同压力下,梗死心脏的容积更大。然而,被动弹性模量下降了41%,降至0.057±0.006 cc⁻¹(P < 0.001)。因此,尽管左心室壁僵硬度可能在心肌梗死后期增加,但可以得出结论,在梗死后1小时,其显著降低。被动弹性模量的计算提供了一种检测此类变化的灵敏方法,而仅靠P-V曲线通常不灵敏。