Suppr超能文献

新合成的大肠杆菌K-12外膜蛋白LamB的组装途径。

Assembly pathway of newly synthesized LamB protein an outer membrane protein of Escherichia coli K-12.

作者信息

Vos-Scheperkeuter G H, Witholt B

出版信息

J Mol Biol. 1984 Jun 5;175(4):511-28. doi: 10.1016/0022-2836(84)90182-7.

Abstract

The assembly of newly induced LamB protein (phage lambda receptor) was investigated in an operon fusion strain of Escherichia coli, in which the lamB gene is expressed under lac promoter control. The induction kinetics both for total cellular and for cell surface-exposed LamB protein were studied by immunochemical detection methods, using two distinct antisera directed against detergent-solubilized LamB trimers and completely denatured LamB monomers, respectively. Anti-trimer antibodies recognized both monomers and trimers, whereas anti-monomer antibodies only reacted with monomers. Provided appropriate solubilization conditions were used, both antisera were able to immunoprecipitate intracellular mature LamB protein quantitatively. Following induction, the first LamB antigenic determinants were detected after 60 to 80 seconds; detection of the newly synthesized protein by anti-monomer antibodies slightly preceded that by anti-trimer antibodies, a finding that could be partly explained by the observation that anti-monomer antibodies recognized a larger fraction of nascent LamB than did anti-trimer antibodies. Exposure of antigenic determinants at the cell surface was delayed for 30 to 50 seconds with respect to their synthesis. Therefore, either translocation or conformational changes must be rate-limiting in the series of processes that eventually convert the newly synthesized protein into its mature outer membrane state. LamB protein was found to occur in at least three clearly distinguishable states. State I is the LamB monomer, state II corresponds to a metastable trimer that dissociates in sodium dodecyl sulphate above 60 degrees C, and state III is the state LamB trimer that dissociates in sodium dodecyl sulphate only at temperatures above 90 degrees C. The chase kinetics of these states showed that conversion of newly synthesized LamB monomers to stable LamB trimers occurred in two stages: state I monomers were chased into metastable state II trimers rapidly (t 1/2 = 20 s), whereas stabilization of state II trimers to state III trimers was a relatively slow (t 1/2 = 5.7 min) process. Based on our results, a timing sequence in the assembly of outer membrane LamB protein is proposed.

摘要

在大肠杆菌的一个操纵子融合菌株中研究了新诱导的LamB蛋白(噬菌体λ受体)的组装,在该菌株中,lamB基因在lac启动子控制下表达。通过免疫化学检测方法,分别使用两种针对去污剂溶解的LamB三聚体和完全变性的LamB单体的不同抗血清,研究了总细胞和细胞表面暴露的LamB蛋白的诱导动力学。抗三聚体抗体识别单体和三聚体,而抗单体抗体仅与单体反应。如果使用适当的溶解条件,两种抗血清都能够定量免疫沉淀细胞内成熟的LamB蛋白。诱导后,在60至80秒后检测到第一个LamB抗原决定簇;抗单体抗体检测新合成的蛋白质略早于抗三聚体抗体,这一发现部分可以通过观察到抗单体抗体比抗三聚体抗体识别更大比例的新生LamB来解释。抗原决定簇在细胞表面的暴露相对于其合成延迟了30至50秒。因此,在最终将新合成的蛋白质转化为其成熟外膜状态的一系列过程中,转位或构象变化必定是限速步骤。发现LamB蛋白至少以三种明显可区分的状态存在。状态I是LamB单体,状态II对应于一种亚稳态三聚体,在高于60℃的十二烷基硫酸钠中解离,状态III是仅在高于90℃的温度下在十二烷基硫酸钠中解离的LamB三聚体状态。这些状态的追踪动力学表明,新合成的LamB单体向稳定的LamB三聚体的转化分两个阶段发生:状态I单体迅速转化为亚稳态II三聚体(t 1/2 = 20秒),而状态II三聚体向状态III三聚体的稳定化是一个相对缓慢的过程(t 1/2 = 5.7分钟)。基于我们的结果,提出了外膜LamB蛋白组装的时间顺序。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验