Eisenberg B R, Milton R L
Am J Anat. 1984 Nov;171(3):273-84. doi: 10.1002/aja.1001710304.
The force produced within skeletal muscle fibers is transmitted to the bone via a myotendinous junction. This junctional region was examined by light and electron microscopy in the sartorius muscles of three Rana temporaria. The muscle fibers tapered and inserted at an angle of about 25 degrees with the connective tissue fascia near the bone. The composition of the structures within the last 100 microns of the fiber was analyzed morphometrically. The T-system, terminal cisternae, and caveolae were the same as in the central region of the muscle fiber. However, the mitochondrial content was higher and the volume of longitudinal sarcoplasmic reticulum was lower than elsewhere in the fiber. The membrane at the end of the fiber had extensive villiform processes interdigitating with the tendon. The surface area of the membrane around the villiform processes was estimated with point-counting techniques and calculated from the stereological equations appropriate for partially anisotropic structures. The extra membrane involved in the myotendinous junction was about 32 times that of the cross-sectional area of the fiber. Part of this additional membrane contained specialized adherens junctions through which the contractile proteins of the muscle are anchored to collagen. The increased area at the myotendinous junction presumably provides greater mechanical strength than a flat termination. The high values of membrane capacitance and specific resistance measured electrophysiologically at the end of the fiber also can be attributed to the characteristics of the terminal membrane structure.
骨骼肌纤维内产生的力通过肌-腱连接传递至骨骼。利用光学显微镜和电子显微镜对三只林蛙缝匠肌的该连接区域进行了检查。肌纤维逐渐变细,并以约25度的角度插入靠近骨骼处的结缔组织筋膜。对纤维最后100微米内结构的组成进行了形态计量分析。T系统、终末池和小窝与肌纤维中央区域的相同。然而,线粒体含量较高,纵向肌质网的体积低于纤维其他部位。纤维末端的膜有广泛的绒毛状突起与肌腱相互交错。利用点计数技术估计绒毛状突起周围膜的表面积,并根据适用于部分各向异性结构的体视学方程进行计算。肌-腱连接中涉及的额外膜面积约为纤维横截面积的32倍。这部分额外的膜包含专门的黏着连接,肌肉的收缩蛋白通过该连接锚定在胶原蛋白上。肌-腱连接处增加的面积大概比平坦的末端提供了更大的机械强度。在纤维末端通过电生理测量得到的高膜电容和比电阻值也可归因于末端膜结构的特性。