Kovaleva S V, Dorozhko A I, Rabinovich S E, Kagan Z S
Biokhimiia. 1984 Apr;49(4):540-6.
Kinetic and allosteric propeties of highly purified "biosynthetic" L-threonine dehydratase from brewer's yeast S. carlbergensis were studied at three pH values, using L-threonine and L-serine as substrates. It was shown that the plot of the initial reaction rate (v) versus initial substrate concentrations ([S]0 pH 6.5 is hyperbolic (Km=5.0.10-2M), while these at pH 7.8 and 9.5 have a faintly pronounced sigmoidal shape with fast occurring saturation plateaus ([S]0.5= 1.0.10-2 and 0.9.10-2M, respectively). the ratios between L-threonine and L-serine dehydratation rates depend on pH. The kinetic properties and the dependence of substrate specificity on pH suggest that the enzyme molecule undergoes pH-induced (at pH 7.0) conformational changes. The determination of pK values of the enzyme functional groups involved in L-threonine binding demonstrated that these groups have pK is approximately equal to 7.5 and 9.5. The latter group was hypothetically identified as a epsilon-NH2-group of the lysine residue. High concentrations of the allosteric inhibitor (L-isoleucine) decrease the rates of L-threonine and L-serine dehydratation and induce the appearance (at pH 6.5) or increase (at pH 7.9 and 9.5) of homotropic cooperative interactions between the active sites in the course of L-threonine dehydratation. The enzyme inhibition by L-isoleucine increases with a decrease of L-threonine concentrations. Low L-isoleucine concentrations, as well as the enzyme activator (L-valine) stimulate the enzyme at non-saturating substrate concentrations (when L-threonine or L-serine are used as substrates) without normalization of (v) versus [S]0 plots. The maximal activation of the enzyme is observed at pHG 8.5--9.0. It is assumed that the molecule of "biosynthetic" L-threonine dehydratase from brewer's yeast contains two types of sites responsible for the effector binding, i.e., "activatory" and "inhibitory" ones.
以L-苏氨酸和L-丝氨酸为底物,在三种pH值条件下研究了来自卡尔斯伯酵母的高度纯化的“生物合成型”L-苏氨酸脱水酶的动力学和别构性质。结果表明,在pH 6.5时,初始反应速率(v)对初始底物浓度([S]0)的曲线呈双曲线(Km = 5.0×10⁻²M),而在pH 7.8和9.5时,这些曲线具有微弱的S形,且快速出现饱和平台([S]0.5分别为1.0×10⁻²和0.9×10⁻²M)。L-苏氨酸和L-丝氨酸脱水速率之比取决于pH。动力学性质以及底物特异性对pH的依赖性表明,酶分子经历了pH诱导(在pH 7.0时)的构象变化。参与L-苏氨酸结合的酶功能基团的pK值测定表明,这些基团的pK约等于7.5和9.5。后一个基团被假设鉴定为赖氨酸残基的ε-NH₂基团。高浓度的别构抑制剂(L-异亮氨酸)降低L-苏氨酸和L-丝氨酸的脱水速率,并在L-苏氨酸脱水过程中诱导活性位点之间出现(在pH 6.5时)或增加(在pH 7.9和9.5时)同促协同相互作用。L-异亮氨酸对酶的抑制作用随L-苏氨酸浓度的降低而增加。低浓度的L-异亮氨酸以及酶激活剂(L-缬氨酸)在非饱和底物浓度下(当使用L-苏氨酸或L-丝氨酸作为底物时)刺激酶,而不会使(v)对[S]0曲线归一化。在pH 8.5 - 9.0时观察到酶的最大激活。据推测,来自酿酒酵母的“生物合成型”L-苏氨酸脱水酶分子包含两种负责效应物结合的位点,即“激活型”和“抑制型”位点。