Matsubara I, Goldman Y E, Simmons R M
J Mol Biol. 1984 Feb 15;173(1):15-33. doi: 10.1016/0022-2836(84)90401-7.
When a skinned fibre prepared from frog skeletal muscle goes from the relaxed to the rigor state at a sarcomere length of about 2.2 micron, the 1, 0 transverse spacing of the filament lattice, measured by X-ray diffraction, decreases by about 11%. In measurements at various sarcomere lengths, the decrease in the spacing was approximately proportional to the degree of overlap between the thick and thin filaments. This suggests that the shrinkage of the lattice is caused by a lateral force produced by cross-bridges. In order to estimate the magnitude of the lateral force, the decrease of spacing between relaxed and rigor states was compared with the shrinkage caused osmotically by adding a high molecular weight polymer, polyvinylpyrrolidone, to the bathing solution. The results indicate that the lateral force produced per unit length of thick filament in the overlap zone is of the same order of magnitude as the axially directed force produced during maximum isometric contraction (10(-10) to 10(-9) N/micron). Experiments in the presence of a high concentration of polyvinylpyrrolidone (100 g/l) show that when the lattice spacing is decreased osmotically beyond a certain value, the lateral force produced when the fibre goes into rigor changes its direction, causing the lattice to swell. This result can be explained by assuming that there is an optimum interfilament spacing at which the cross-bridges produce no lateral force. At other spacings, the lateral force tends to displace the filament lattice toward that optimum value.
当从青蛙骨骼肌制备的去皮纤维在肌节长度约为2.2微米时从松弛状态转变为僵直状态时,通过X射线衍射测量的细丝晶格的1,0横向间距减小约11%。在不同肌节长度的测量中,间距的减小大致与粗、细肌丝之间的重叠程度成正比。这表明晶格的收缩是由横桥产生的侧向力引起的。为了估计侧向力的大小,将松弛状态和僵直状态之间间距的减小与通过向浴液中添加高分子量聚合物聚乙烯吡咯烷酮而产生的渗透收缩进行了比较。结果表明,在重叠区域中每单位长度粗肌丝产生的侧向力与最大等长收缩期间产生的轴向力(10^(-10)至10^(-9) N/微米)处于同一数量级。在高浓度聚乙烯吡咯烷酮(100 g/l)存在下的实验表明,当晶格间距因渗透作用减小到超过一定值时,纤维进入僵直状态时产生的侧向力会改变方向,导致晶格膨胀。这个结果可以通过假设存在一个最佳的丝间间距来解释,在这个间距下横桥不产生侧向力。在其他间距下,侧向力倾向于将细丝晶格向那个最佳值移动。