Ferrone F A, Hofrichter J, Sunshine H R, Eaton W A
Biophys J. 1980 Oct;32(1):361-80. doi: 10.1016/S0006-3495(80)84962-9.
The kinetics of deoxyhemoglobin S gelation have been investigated using photolytic dissociation of the carbon monoxide complex to initiate the process. Measurements over a wide range of times, 10(-3)-10(4) show that both the concentration dependence of the tenth-time (i.e., the time required to complete one-tenth the reaction) and the time dependence of the process decrease as gelation speeds up. In slowly gelling samples, where single domains of polymers are formed in the small sample volumes employed with this technique (1-2 x 10(-9) cm3), there is a marked increase in the variability of the tenth-times. These results are explained by a mechanism in which gelation is initiated by homogeneous nucleation of polymers in the bulk solution phase, followed by heterogeneous nucleation on the surface of existing polymers. At the lowest concentrations, homogeneous nucleation is so improbable that stochastic behavior is observed in the small sample volumes, and heterogeneous nucleation is the dominant pathway for polymer formation, thereby accounting for the high time dependence. At the highest concentrations homogeneous nucleation becomes much more probable, and the time dependence decreases. The decrease in concentration dependence of the tenth-time with increasing concentration results from a decrease in size of both the homogeneous and heterogeneous critical nuclei. The model rationalizes the major observations on the kinetics of gelation of deoxyhemoglobin S, and is readily testable by further experiments.
利用一氧化碳复合物的光解解离来引发过程,对脱氧血红蛋白S凝胶化的动力学进行了研究。在10⁻³至10⁴的广泛时间范围内进行测量,结果表明,随着凝胶化速度加快,十分之一反应时间(即完成十分之一反应所需的时间)的浓度依赖性以及该过程的时间依赖性均降低。在缓慢凝胶化的样品中,在采用该技术的小样品体积(1 - 2×10⁻⁹ cm³)中形成聚合物的单个区域时,十分之一反应时间的变异性显著增加。这些结果由一种机制来解释,即凝胶化由本体溶液相中聚合物的均匀成核引发,随后在现有聚合物表面发生异相成核。在最低浓度下,均匀成核极不可能发生,以至于在小样品体积中观察到随机行为,而异相成核是聚合物形成的主要途径,从而导致高度的时间依赖性。在最高浓度下,均匀成核变得更有可能发生,时间依赖性降低。随着浓度增加,十分之一反应时间的浓度依赖性降低是由于均匀和异相临界核的尺寸减小所致。该模型解释了关于脱氧血红蛋白S凝胶化动力学的主要观察结果,并且很容易通过进一步的实验进行检验。