Chang B S, Fischer N L
Department of Formulation and Pharmaceutical Development, Synergen, Inc., Boulder, Colorado 80303, USA.
Pharm Res. 1995 Jun;12(6):831-7. doi: 10.1023/a:1016200818343.
An efficient freeze-drying cycle for recombinant human interleukin-1 receptor antagonist (rhIL-1ra) formulations, which contained glycine and sucrose as excipients, was developed.
Development was based on characterizing the frozen formulations by thermal analysis and by examining the effect of various lyophilization process parameters on the sublimation rate of ice.
Thermal analysis showed that the metastable glass of glycine in frozen formulation could be devitrified by slowly warming the frozen product to -15 degrees C. During drying, the sublimation rate of ice was increased as a linear function of the difference between the vapor pressure of ice at the product temperature (PO) and the chamber pressure (PC). Therefore, the product temperature (Tp) was maintained as high as possible at temperatures below Tg' of the formulation, in order to maximize the PO without allowing the collapse of cake. Although various combinations of shelf temperatures and chamber pressures could be used to obtain the same Tp, the combination of higher shelf temperature and lower chamber pressure was used to maximize sublimation rate.
A single-step drying cycle was developed to take advantage of these observations. The shelf temperature was set for the secondary drying and the product temperature during primary drying was maintained below Tg' by adjusting the chamber pressure. As the sublimation completed, the product temperature increased naturally to the shelf temperature for the secondary drying. This process resulted in successful drying of 1 ml of rhIL-1ra formulation to 0.4% moisture content within 6 hours.
开发一种用于重组人白细胞介素-1受体拮抗剂(rhIL-1ra)制剂的高效冻干循环,该制剂含有甘氨酸和蔗糖作为辅料。
基于通过热分析表征冷冻制剂以及研究各种冻干工艺参数对冰升华速率的影响来进行开发。
热分析表明,通过将冷冻产品缓慢升温至-15℃,冷冻制剂中甘氨酸的亚稳态玻璃态可发生失透。在干燥过程中,冰的升华速率随产品温度下冰的蒸气压(PO)与腔室压力(PC)之差的线性函数而增加。因此,在低于制剂Tg'的温度下尽可能将产品温度(Tp)保持得高一些,以便在不使饼块塌陷的情况下使PO最大化。尽管可以使用搁板温度和腔室压力的各种组合来获得相同的Tp,但使用较高搁板温度和较低腔室压力的组合来最大化升华速率。
利用这些观察结果开发了单步干燥循环。设定搁板温度用于二次干燥,并通过调节腔室压力在一次干燥期间将产品温度保持在Tg'以下。随着升华完成,产品温度自然升高至二次干燥的搁板温度。该过程在6小时内成功将1 ml的rhIL-1ra制剂干燥至水分含量为0.4%。