Suppr超能文献

3T3细胞铺展与在玻璃和硅烷表面的黏附强度之间的关系。

Relationship between 3T3 cell spreading and the strength of adhesion on glass and silane surfaces.

作者信息

Truskey G A, Proulx T L

机构信息

Department of Biomedical Engineering, Duke University, Durham, NC 27706.

出版信息

Biomaterials. 1993;14(4):243-54. doi: 10.1016/0142-9612(93)90114-h.

Abstract

Cell detachment by laminar shear stresses was used to characterize cellular interactions with hydrophilic glass and hydrophobic silane. In this study, we examined whether smaller, rounder cells were preferentially detached by laminar flow, and whether cell detachment occurred by dissociation of adhesion proteins and their membrane receptors or rupture of the membrane. Shear-induced detachment from glass and silane were similar after 0.5 h static attachment to the surfaces, even though 3T3 cells had a greater projected area on silane. No particular cell size was preferentially detached by fluid shear stresses. After 2 h attachment and spreading, 3T3 cells were more easily detached from the silane surface even though the cells were more spread than on glass. On glass, smaller cells were preferentially detached below 30 dyne/cm2, increasing the mean projected area of the population. Above 30 dyne/cm2, larger cells also detached from the surface. Cell detachment from the silane surfaces did not show any size preference. The strength of adhesion and projected areas on both surfaces increased significantly when the surfaces were preincubated with fibronectin. Simple geometric models of spreading cells were used to estimate the forces exerted on cells. The hydrodynamic forces exerted on spreading cells were similar, but the bond density needed to resist detachment declined as the projected area increased. Analysis of Dil-C18(3) membrane fragments indicated that cell detachment by membrane rupture was a significant mechanism of cell detachment from glass for shear stresses above 40 dyne/cm2, but was unimportant for cell detachment from the silane surfaces. The results indicate that differences in the strength of 3T3 cell adhesion were probably due to differences in bond strength and the numbers of receptor-ligand bonds formed on the two surfaces and, on glass, cell detachment due to membrane failure at higher shear stresses.

摘要

利用层流剪应力使细胞脱离来表征细胞与亲水性玻璃和疏水性硅烷的相互作用。在本研究中,我们考察了更小、更圆的细胞是否更易被层流分离,以及细胞脱离是通过粘附蛋白及其膜受体的解离还是细胞膜的破裂发生的。在静态附着于表面0.5小时后,玻璃和硅烷表面的剪切诱导细胞脱离情况相似,尽管3T3细胞在硅烷表面的投影面积更大。流体剪应力并未优先分离特定大小的细胞。在附着并铺展2小时后,尽管3T3细胞在硅烷表面比在玻璃表面铺展得更充分,但它们更容易从硅烷表面脱离。在玻璃表面,低于30达因/平方厘米时较小的细胞优先脱离,这增加了群体的平均投影面积。高于30达因/平方厘米时,较大的细胞也从表面脱离。从硅烷表面脱离的细胞未表现出任何大小偏好。当表面用纤连蛋白预孵育时,两个表面上的粘附强度和投影面积均显著增加。利用铺展细胞的简单几何模型来估算施加在细胞上的力。施加在铺展细胞上的流体动力相似,但抵抗脱离所需的键密度随投影面积增加而降低。对Dil-C18(3)膜片段的分析表明,对于高于40达因/平方厘米的剪应力,通过细胞膜破裂导致的细胞脱离是细胞从玻璃表面脱离的一个重要机制,但对于细胞从硅烷表面脱离并不重要。结果表明,3T3细胞粘附强度的差异可能是由于两个表面上形成的键强度和受体-配体键数量的差异,以及在玻璃表面,较高剪应力下由于细胞膜破坏导致的细胞脱离。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验