Correia J J, Chaires J B
Department of Biochemistry, University of Mississippi Medical Center, Jackson 39216.
Methods Enzymol. 1994;240:593-614. doi: 10.1016/s0076-6879(94)40065-2.
Monte Carlo simulations of neighbor exclusion models have been used to demonstrate the importance of collecting and fitting data over a wide range of saturation. Low saturation data are important for good estimates of the affinity K of a drug or protein for the lattice site. High saturation data are important for distinguishing between negatively cooperative and noncooperative binding modes. Neglect of negative cooperativity (omega < 1) has in general little effect on the estimation of K. The error is mostly absorbed by increasing the value of n. This kind of behavior was previously observed with the fitting of nonideal, monomer-dimer, ultracentrifugation data where variations in B, the second virial coefficient, and K2, the dimerization equilibrium constant, are highly correlated, thus making their individual determination difficult. Within experimental error the distinction between a noncooperative model [Eq. (1)] and a negatively cooperative model [Eq. (3) or (4) with omega < 1] may require additional evidence to justify the choice of one model over another. For example, for homogeneous lattices of synthetic deoxyoligonucleotides, n may be constrained with some validity, thus allowing a more accurate and precise determination of K and omega. In fact, n may be established independently, for example, by nuclear magnetic resonance (NMR) methods. However, the assumption of an integral value of n for natural DNA samples may not be valid because of sequence heterogeneity. Unconstrained fitting of negatively cooperative data to Eq. (4) will thus be a very difficult problem (Table V). At an experimental error of only 2.3%, n and K can be reasonably determined but with a large error in omega. Data from the final 20% of saturation are essential in extracting omega. This may in part explain the absence of more reports of negatively cooperative behavior in the literature. This analysis is independent of the systematic error that may be induced by the transformation of data to the Scatchard plot, or the omission of drug self-association, or the occurrence of wall binding by ligand, or variable point density, or non-Gaussian noise, or the occurrence of another mode of binding distinct from the models of McGhee and von Hippel. Each of these will introduce additional error, possibly biased error, in the parameters estimated; however, this does not obviate our conclusion. Even under these ideal circumstances there are serious limitations that must be considered when fitting neighbor exclusion model data. The direct fitting of absorbance data [to Eq. (2) or functions that incorporate other parameters] will also be sensitive to these considerations.
邻位排斥模型的蒙特卡罗模拟已被用于证明在广泛的饱和度范围内收集和拟合数据的重要性。低饱和度数据对于准确估计药物或蛋白质与晶格位点的亲和力K很重要。高饱和度数据对于区分负协同结合模式和非协同结合模式很重要。一般来说,忽略负协同性(ω<1)对K的估计影响不大。误差大多通过增加n值来吸收。这种行为先前在非理想的单体-二聚体超速离心数据拟合中观察到,其中第二维里系数B和二聚化平衡常数K2的变化高度相关,因此难以单独确定它们。在实验误差范围内,非协同模型[式(1)]和负协同模型[式(3)或(4),ω<1]之间的区分可能需要额外的证据来证明选择一个模型而不是另一个模型的合理性。例如,对于合成脱氧寡核苷酸的均匀晶格,n可能在一定程度上有效受限,从而允许更准确和精确地确定K和ω。事实上,n可以独立确定,例如通过核磁共振(NMR)方法。然而,由于序列异质性,对于天然DNA样本假设n为整数值可能无效。因此,将负协同数据无约束地拟合到式(4)将是一个非常困难的问题(表V)。在仅2.3%的实验误差下,可以合理地确定n和K,但ω的误差较大。饱和度最后20%的数据对于提取ω至关重要。这可能部分解释了文献中负协同行为的报道较少的原因。这种分析与数据转换为Scatchard图、药物自缔合的遗漏、配体壁结合的发生、可变点密度、非高斯噪声或与McGhee和von Hippel模型不同的另一种结合模式的出现可能引起的系统误差无关。这些因素中的每一个都会在估计的参数中引入额外的误差,可能是有偏差的误差;然而,这并不妨碍我们的结论。即使在这些理想情况下,在拟合邻位排斥模型数据时也必须考虑严重的局限性。吸光度数据的直接拟合[到式(2)或包含其他参数的函数]也将对这些因素敏感。