Petersen G, Song D, Hügle-Dörr B, Oldenburg I, Bautz E K
Institute of Molecular Genetics, University of Heidelberg, Germany.
Mol Gen Genet. 1995 Dec 10;249(4):425-31. doi: 10.1007/BF00287104.
Epitope mapping with mono- or polyclonal antibodies has so far been done either by dissecting the antigens into overlapping polypeptides in the form of recombinantly expressed fusion proteins, or by synthesizing overlapping short peptides, or by a combination of both methods. Here, we report an alternative method which involves the generation of random gene fragments of approximately 50-200 bp in length and cloning these into the 5' terminus of the protein III gene of fd phages. Selection for phages that bind a given monoclonal antibody and sequencing the DNA inserts of immunopositive phages yields derived amino acid sequences containing the desired epitope. A monoclonal antibody (mAb 215) directed against the largest subunit of Drosophila RNA polymerase II (RPB215) was used to map the corresponding epitope in a fUSE5 phage display library made of random DNA fragments from plasmid DNA containing the entire gene. After a single round of panning with this phage library, bacterial colonies were obtained which produced fd phages displaying the mAb 215 epitope. Sequencing of single-stranded phage DNA from a number of positive colonies (recognized by the antibody on colony immunoblots) resulted in overlapping sequences all containing the 15mer epitope determined by mapping with synthetic peptides. Similarly, we have localized the epitopes recognized by a mouse monoclonal antibody directed against the human p53 protein, and by a mouse monoclonal antibody directed against the human cytokeratin 19 protein. Identification of positive colonies after the panning procedure depends on the detection system used (colony immunoblot or ELISA) and there appear to be some restrictions to the use of linker-encoded amino acids for optimal presentation of epitopes. A comparison with epitope mapping by synthetic peptides shows that the phage display method allows one to map linear epitopes down to a size only slightly larger than the true epitope. In general, our phage display method is faster, easier, and cheaper than the construction of overlapping fusion proteins or the use of synthetic peptides, especially in cases where the antigen is a large polypeptide such as the 215 kDa subunit of eukaryotic RNA polymerase II.
迄今为止,使用单克隆或多克隆抗体进行表位作图,要么是将抗原切割成重组表达融合蛋白形式的重叠多肽,要么是合成重叠短肽,或者是两种方法结合使用。在此,我们报告一种替代方法,该方法涉及生成长度约为50 - 200 bp的随机基因片段,并将这些片段克隆到fd噬菌体蛋白III基因的5'末端。筛选与给定单克隆抗体结合的噬菌体,并对免疫阳性噬菌体的DNA插入片段进行测序,可得到包含所需表位的推导氨基酸序列。一种针对果蝇RNA聚合酶II最大亚基(RPB215)的单克隆抗体(mAb 215),被用于在由包含完整基因的质粒DNA的随机DNA片段制成的fUSE5噬菌体展示文库中定位相应表位。用该噬菌体文库进行一轮淘选后,获得了产生展示mAb 215表位的fd噬菌体的细菌菌落。对多个阳性菌落(通过菌落免疫印迹上的抗体识别)的单链噬菌体DNA进行测序,得到了重叠序列,所有序列都包含通过合成肽作图确定的15聚体表位。同样,我们已经定位了针对人p53蛋白的小鼠单克隆抗体和针对人细胞角蛋白19蛋白的小鼠单克隆抗体所识别的表位。淘选过程后阳性菌落的鉴定取决于所使用的检测系统(菌落免疫印迹或ELISA),并且对于使用接头编码氨基酸以实现表位的最佳呈现似乎存在一些限制。与通过合成肽进行表位作图的比较表明,噬菌体展示方法能够定位小至仅略大于真实表位大小的线性表位。一般来说,我们的噬菌体展示方法比构建重叠融合蛋白或使用合成肽更快、更容易且更便宜,特别是在抗原是大的多肽(如真核RNA聚合酶II的215 kDa亚基)的情况下。