Wheeler K A, Lamb H K, Hawkins A R
Department of Biochemistry and Genetics, New Medical School, University of Newcastle upon Tyne, U.K.
Biochem J. 1996 Apr 1;315 ( Pt 1)(Pt 1):195-205. doi: 10.1042/bj3150195.
The quinic acid ulitization (qut) pathway in Aspergillus nidulans is a dispensable carbon utilization pathway that catabolizes quinate to protocatechuate via dehydroquinate and dehydroshikimate(DHS). At the usual in vitro growth pH of 6.5, quinate enters the mycelium by means of a specific permease and is converted into PCA by the sequential action of the enzymes quinate dehydrogenase, 3-dehydroquinase and DHS dehydratase. The extent of control on metabolic flux exerted by the permease and the three pathway enzymes was investigated by applying the techniques of Metabolic Control Analysis. The flux control coefficients for each of the three quinate pathway enzymes were determined empirically, and the flux control coefficient of the quinate permease was inferred by use of the summation theorem. There measurements implied that, under the standard growth conditions used, the values for the flux control coefficients of the components of the quinate pathway were: quinate permease, 0.43; quinate dehydrogenase, 0.36; dehydroquinase, 0.18; DHS dehydratase, <0,03. Attempts to partially decouple quinate permease from the control over flux by measuring flux at pH 3.5 (when a significant percentage of the soluble quinate is protonated and able to enter the mycelium without the aid of a permease) led to an increase of approx. 50% in the flux control coefficient for dehydroquinase. Taken together with the fact that A. nidulans has a very efficient pH homeostasis mechanism, these experiments are consistent with the view that quinate permease exerts a high degree of control over pathway flux under the standard laboratory growth conditions at pH 6.5. The enzymes quinate dehydrogenase and 3-dehydroquinase have previously been overproduced in Escherichia coli, and protocols for their purification published. The remaining qut pathway enzyme DHS dehydratase was overproduced in E. coli and a purification protocol established. The purified DHS dehydratase was shown to have a K(m) of 530 microM for its substrate DHS and a requirement for bivalent metal cations that could be fulfilled by Mg(2+), Mn(2+) or Zn(2+). All three qut pathway enzymes were purified in bulk and their elasticity coefficients with respect to the three quinate pathway intermediates were derived over a range of concentrations in a core tricine/NaOH buffer, augmented with necessary cofactors and bivalent cations as appropriate. Using these empirically determined relative values, in conjunction with the connectivity theorem, the relative ratios of the flux control coefficients for the various quinate pathway enzymes, and how this control shifts between them, was determined over a range of possible metabolic concentrations. These calculations, although clearly subject to caveates about the relationswhip between kinetic measurements in vitro and the situation in vivo, were able to successfully predict the hiearchy of control observed under the standard laboratory growth conditions. The calculations imply that the hierarchy of control exerted by the quinate pathway enzymes is stable and relatively insensitive to changing metabolite concentrations in the ranges most likely to correspond to those found in vivo. The effects of substituting the type I 3-dehydroquinases from Salmonella typhi and the A. nidulans AROM protein (a pentadomain protein catalysing the conversion of 3-deoxy-D-arabinoheptulosonic acid 7-phosphate into 5-enolpyruvylshikimate 3 phosphate), and the Mycobacterium tuberculosis type II 3-dehydroquinase, in the quinate pathway were investigated and found to have an effect. In the case of S. typhi and A. nidulans, overproduction of heterologous dehydroquinase led to a diminuation of pathway flux caused by a lowering of in vivo quinate dehydrogenase levels increased above those of the wild type. We speculate that these changes in qu
构巢曲霉中的奎尼酸利用(qut)途径是一条可有可无的碳利用途径,它通过脱氢奎尼酸和脱氢莽草酸(DHS)将奎尼酸分解代谢为原儿茶酸。在通常的体外生长pH值6.5下,奎尼酸通过一种特定的通透酶进入菌丝体,并通过奎尼酸脱氢酶、3 - 脱氢奎尼酸酶和DHS脱水酶的顺序作用转化为PCA。通过应用代谢控制分析技术,研究了通透酶和三种途径酶对代谢通量的控制程度。通过实验确定了三种奎尼酸途径酶各自的通量控制系数,并利用求和定理推断出奎尼酸通透酶的通量控制系数。这些测量结果表明,在所用的标准生长条件下,奎尼酸途径各组分的通量控制系数值为:奎尼酸通透酶,0.43;奎尼酸脱氢酶,0.36;3 - 脱氢奎尼酸酶, 0.18;DHS脱水酶,<0.03。通过在pH 3.5下测量通量(此时相当一部分可溶性奎尼酸质子化,能够在无需通透酶帮助的情况下进入菌丝体)来尝试使奎尼酸通透酶与通量控制部分解耦,结果导致3 - 脱氢奎尼酸酶的通量控制系数增加了约50%。结合构巢曲霉具有非常有效的pH稳态机制这一事实,这些实验与以下观点一致:在pH 6.5的标准实验室生长条件下,奎尼酸通透酶对途径通量施加高度控制。奎尼酸脱氢酶和3 - 脱氢奎尼酸酶此前已在大肠杆菌中过量表达,并发表了其纯化方案。奎尼酸途径其余的酶DHS脱水酶在大肠杆菌中过量表达并建立了纯化方案。纯化的DHS脱水酶对其底物DHS的K(m)为530 microM,并且需要二价金属阳离子,Mg(2+)、Mn(2+)或Zn(2+)可满足这一需求。三种奎尼酸途径酶均大量纯化,并在一系列浓度的核心tricine/NaOH缓冲液中,添加必要的辅因子和适当的二价阳离子,得出它们相对于三种奎尼酸途径中间体的弹性系数。利用这些通过实验确定的值,并结合连通性定理,在一系列可能的代谢浓度范围内,确定了各种奎尼酸途径酶通量控制系数的相对比例,以及这种控制在它们之间如何转移。这些计算虽然显然受到关于体外动力学测量与体内情况之间关系的限制,但能够成功预测在标准实验室生长条件下观察到的控制层次。计算结果表明,奎尼酸途径酶施加控制的层次是稳定的,并且在最有可能与体内发现的浓度相对应的范围内,对代谢物浓度变化相对不敏感。研究了用来自伤寒沙门氏菌的I型3 - 脱氢奎尼酸酶、构巢曲霉的AROM蛋白(一种催化7 - 磷酸 - 3 - 脱氧 - D - 阿拉伯庚酮酸转化为5 - 烯醇丙酮酸莽草酸 - 3 - 磷酸的五结构域蛋白)以及结核分枝杆菌的II型3 - 脱氢奎尼酸酶替代奎尼酸途径中的酶的效果,发现有影响。就伤寒沙门氏菌和构巢曲霉而言,异源3 - 脱氢奎尼酸酶的过量表达导致途径通量降低,这是由于体内奎尼酸脱氢酶水平降低超过野生型水平所致。我们推测这些在qu方面的变化…… (原文最后似乎不完整)