Werneburg B G, Ahn J, Zhong X, Hondal R J, Kraynov V S, Tsai M D
Department of Chemistry, Ohio State University, Columbus 43210, USA.
Biochemistry. 1996 Jun 4;35(22):7041-50. doi: 10.1021/bi9527202.
DNA polymerase beta (pol beta) is the smallest and least complex DNA polymerase. The structure of the enzyme is well understood, but little is known about its catalytic properties, particularly processivity and fidelity. Pre-steady-state analysis of the incorporation of a single nucleotide into a short 25/45 oligonucleotide primer-template by pol beta was used to define the kinetic parameters of the polymerase. In addition, nucleotide analogs and site-specific mutants, along with structural analyses, were used to probe the structure-function relationship of pol beta. Several significant findings have been obtained: (i) The catalysis by pol beta is processive and displays an initial burst under pre-steady-state conditions, but the processivity is poor compared to other polymerases. (ii) The fidelity of pol beta is also low relative to other polymerases. (iii) Under pre-steady-state conditions the chemical step appears to be only partially rate-limiting on the basis of the low thio effect (4.3), defined as kpol(dNTP)/kpol(dNTP alpha S). The thio effect increases to 9 for incorporation of an incorrect nucleotide. These results are consistent with the existence of a substrate-induced conformational change that is also partially rate-limiting. (iv) A comparison between the two-dimensional NMR spectra of the wild-type and mutant enzymes indicates that the mutations at position 283 did not significantly perturb the structure of the enzyme. The conformational stability of the mutants is also unperturbed. Thus, R283 is not important to the overall structure of the enzyme. (v) The results of kinetic analyses of R283A and R283K mutants indicate that the hydrogen bond between R283 of pol beta and the template is important for catalysis. Both R283A and R283K mutants displayed decreases in catalytic efficiency by a factor of ca. 200 relative to wild-type pol beta. The mutants are also less faithful by a factor of 2-4, in terms of the T-G mispair vs the T-A correct pair. The perturbation, however, could occur at both the implied conformational step and the chemical step, since the thio effects of the mutants for both correct and incorrect nucleotides are similar to those of WT pol beta.
DNA聚合酶β(polβ)是最小且结构最简单的DNA聚合酶。该酶的结构已被充分了解,但对其催化特性,尤其是持续合成能力和保真度却知之甚少。通过对polβ将单个核苷酸掺入短的25/45寡核苷酸引物-模板的预稳态分析来确定该聚合酶的动力学参数。此外,核苷酸类似物和位点特异性突变体,连同结构分析,被用于探究polβ的结构-功能关系。已获得了几个重要发现:(i)polβ的催化具有持续性,并且在预稳态条件下呈现初始爆发,但与其他聚合酶相比,其持续合成能力较差。(ii)相对于其他聚合酶,polβ的保真度也较低。(iii)在预稳态条件下,基于低硫效应(4.3),化学步骤似乎仅部分限速,硫效应定义为kpol(dNTP)/kpol(dNTPαS)。对于掺入错误核苷酸,硫效应增加到9。这些结果与存在底物诱导的构象变化一致,该构象变化也部分限速。(iv)野生型和突变型酶的二维核磁共振谱的比较表明,283位的突变并未显著扰乱酶的结构。突变体的构象稳定性也未受干扰。因此,R283对酶的整体结构并不重要。(v)R283A和R283K突变体的动力学分析结果表明,polβ的R283与模板之间的氢键对催化很重要。相对于野生型polβ,R283A和R283K突变体的催化效率均降低了约200倍。就T-G错配与T-A正确配对而言,突变体的保真度也降低了2至4倍。然而,这种扰动可能发生在隐含的构象步骤和化学步骤,因为突变体对正确和错误核苷酸的硫效应与野生型polβ相似。