Suppr超能文献

[冠状动脉支架植入术后与单纯球囊血管成形术相比心肌灌注储备的正常化]

[Normalization of myocardial perfusion reserve after coronary stent implantation in comparison with balloon angioplasty alone].

作者信息

Haude M, Caspari G, Baumgart D, Eick B, Liu F, Brennecke R, Meyer J, Erbel R

机构信息

Abteilung für Kardiologie, Universitätsklinik Essen.

出版信息

Z Kardiol. 1996 Apr;85(4):260-72.

PMID:8693769
Abstract

Stents scaffold coronary arteries after angioplastic treatment and inhibit elastic recoil resulting in a larger and more circular focal lumen. In 25 patients with significant stenoses of the left anterior descending coronary artery, presenting no collaterals or myocardial infarction, EKG-gated digital subtraction angiograms were recorded at baseline and during hyperemia induced by intracoronary injection of 12 mg papaverine before and after balloon angioplasty, and after adjunct implantation of a single Palmaz-Schatz stent. Densitometric evaluation revealed the time parameters contrast medium appearance time (MCAT) rise time (RT) and mean transit time (MTT) and maximum intensity (Imax). Myocardial perfusion reserve (MPR1) was calculated as the ratio of baseline MCAT and hyperemic MCAT multiplied by the ratio of hyperemic Imax and baseline Imax while MPR2 was calculated as the ratio of baseline RT and hyperemic RT. Maximum flow ratio (MaxFR) was calculated as the ratio of preprocedural hyperemic MTT and postprocedural hyperemic MTT. Post-stenotic MPR1 increased from 1.36 +/- 0.28 to 2.50 +/- 1.20 and to 3.40 +/- 0.58 (ANOVA p < 0.05), while reference MPR1 remained unchanged with 3.40 +/- 0.60. Post-stenotic MPR2 increased from 1.57 +/- 0.14 to 2.59 +/- 0.86 after balloon angioplasty and to 3.10 +/- 0.41 after stenting (ANOVA p < 0.05), while reference MPR2 remained unchanged with 3.10 +/- 0.40. MaxFR was 2.13 +/- 0.53 after balloon angioplasty and 2.83 +/- 0.35 after stenting (p < 0.05). A good correlation was found between minimal stenosis diameter and MPR1 or MPR2 (MPR1: r = 0.94; MPR2: r = 0.87) and between luminal gain and MaxFR (r = 0.75). A negative correlation was measured between recoil, defined as the difference between inflated balloon diameter and resulting minimal stenosis diameter, and MPR1 and MPR2 and MaxFR (MPR1: r = -0.86; MPR2 r = -0.80; MaxFR r = -0.83). In conclusion, adjunct coronary stent implantation normalized post-stenotic myocardial perfusion immediately in contrast to balloon angioplasty alone resulting from a larger postprocedural lumen and a more pronounced inhibition of elastic recoil.

摘要

血管成形术治疗后,支架为冠状动脉提供支架结构,并抑制弹性回缩,从而形成更大且更圆形的局灶性管腔。在25例左前降支冠状动脉严重狭窄、无侧支循环或心肌梗死的患者中,在球囊血管成形术前、术后以及辅助植入单个Palmaz-Schatz支架后,记录了基线时以及冠状动脉内注射12mg罂粟碱诱导充血期间的心电图门控数字减影血管造影。密度测定评估显示了时间参数造影剂出现时间(MCAT)、上升时间(RT)、平均通过时间(MTT)和最大强度(Imax)。心肌灌注储备(MPR1)计算为基线MCAT与充血MCAT的比值乘以充血Imax与基线Imax的比值,而MPR2计算为基线RT与充血RT的比值。最大血流比(MaxFR)计算为术前充血MTT与术后充血MTT的比值。狭窄后MPR1从1.36±0.28增加到2.50±1.20,再增加到3.40±0.58(方差分析p<0.05),而参考MPR1保持不变,为3.40±0.60。狭窄后MPR2在球囊血管成形术后从1.57±0.14增加到2.59±0.86,在支架植入后增加到3.10±0.41(方差分析p<0.05),而参考MPR2保持不变,为3.10±0.40。MaxFR在球囊血管成形术后为2.13±0.53,在支架植入后为2.83±0.35(p<0.05)。发现最小狭窄直径与MPR1或MPR2之间(MPR1:r = 0.94;MPR2:r = 0.87)以及管腔增益与MaxFR之间(r = 0.75)存在良好的相关性。测量到回缩(定义为膨胀球囊直径与由此产生的最小狭窄直径之间的差值)与MPR1、MPR2和MaxFR之间呈负相关(MPR1:r = -0.86;MPR2 r = -0.80;MaxFR r = -0.83)。总之,与单独的球囊血管成形术相比,辅助冠状动脉支架植入可立即使狭窄后心肌灌注正常化,这是由于术后管腔更大以及对弹性回缩的抑制更明显。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验