Liu S Y, Wiegel J, Gherardini F C
Department of Microbiology and Center for Biological Resources Recovery, University of Georgia, Athens 30602, USA.
J Bacteriol. 1996 Oct;178(20):5938-45. doi: 10.1128/jb.178.20.5938-5945.1996.
An unusual xylose isomerase produced by Thermoanaerobacterium strain JW/SL-YS 489 was purified 28-fold to gel electrophoretic homogeneity, and the biochemical properties were determined. Its pH optimum distinguishes this enzyme from all other previously described xylose isomerases. The purified enzyme had maximal activity at pH 6.4 (60 degrees C) or pH 6.8 (80 degrees C) in a 30-min assay, an isoelectric point at 4.7, and an estimated native molecular mass of 200 kDa, with four identical subunits of 50 kDa. Like other xylose isomerases, this enzyme required Mn2+, Co2+, or Mg2+ for thermal stability (stable for 1 h at 82 degrees C in the absence of substrate) and isomerase activity, and it preferred xylose as a substrate. The gene encoding the xylose isomerase was cloned and expressed in Escherichia coli, and the complete nucleotide sequence was determined. Analysis of the sequence revealed an open reading frame of 1,317 bp that encoded a protein of 439 amino acid residues with a calculated molecular mass of 50 kDa. The biochemical properties of the cloned enzyme were the same as those of the native enzyme. Comparison of the deduced amino acid sequence with sequences of other xylose isomerases in the database showed that the enzyme had 98% homology with a xylose isomerase from a closely related bacterium, Thermoanaerobacterium saccharolyticum B6A-RI. In fact, only seven amino acid differences were detected between the two sequences, and the biochemical properties of the two enzymes, except for the pH optimum, are quite similar. Both enzymes had a temperature optimum at 80 degrees C, very similar isoelectric points (pH 4.7 for strain JW/SL-YS 489 and pH 4.8 for T. saccharolyticum B6A-RI), and slightly different thermostabilities (stable for 1 h at 80 and 85 degrees C, respectively). The obvious difference was the pH optimum (6.4 to 6.8 and 7.0 to 7.5, respectively). The fact that the pH optimum of the enzyme from strain JW/SL-YS 489 was the property that differed significantly from the T. saccharolyticum B6A-RI xylose isomerase suggested that one or more of the observed amino acid changes was responsible for this observed difference.
嗜热栖热放线菌JW/SL-YS 489菌株产生的一种不同寻常的木糖异构酶经纯化后,其凝胶电泳纯度提高了28倍,并对其生化特性进行了测定。其最适pH值使该酶与之前描述的所有其他木糖异构酶区分开来。在30分钟的测定中,纯化后的酶在pH 6.4(60℃)或pH 6.8(80℃)时具有最大活性,等电点为4.7,估计天然分子量为200 kDa,由四个50 kDa的相同亚基组成。与其他木糖异构酶一样,该酶需要Mn2+、Co2+或Mg2+来维持热稳定性(在无底物时于82℃稳定1小时)和异构酶活性,并且它更倾向于以木糖作为底物。编码木糖异构酶的基因被克隆并在大肠杆菌中表达,同时测定了其完整的核苷酸序列。序列分析揭示了一个1317 bp的开放阅读框,编码一个439个氨基酸残基的蛋白质,计算分子量为50 kDa。克隆酶的生化特性与天然酶相同。将推导的氨基酸序列与数据库中其他木糖异构酶的序列进行比较,结果表明该酶与密切相关细菌嗜热栖热放线菌B6A-RI的木糖异构酶具有98%的同源性。实际上,在这两个序列之间仅检测到七个氨基酸差异,并且除了最适pH值外,这两种酶的生化特性相当相似。两种酶的最适温度均为80℃,等电点非常相似(JW/SL-YS 489菌株为pH 4.7,嗜热栖热放线菌B6A-RI为pH 4.8),热稳定性略有不同(分别在80℃和85℃稳定1小时)。明显的差异在于最适pH值(分别为6.4至6.8和7.0至7.5)。JW/SL-YS 489菌株酶的最适pH值这一特性与嗜热栖热放线菌B6A-RI木糖异构酶有显著差异,这表明观察到的一个或多个氨基酸变化是造成这种差异的原因。