Martin R B, Lau S T, Mathews P V, Gibson V A, Stover S M
Orthopaedic Research Laboratories, School of Medicine, University of California at Davis 95616, USA.
J Biomech. 1996 Dec;29(12):1515-21.
We studied birefringence as an indicator of collagen fiber orientation in the diaphysis of the equine third metacarpal bone. We had previously shown that tissue from the lateral cortex of this bone is stronger monotonically, but less fatigue resistant, than tissue from the medial and dorsal regions. To learn whether collagen fiber orientation might play a role in this regional specialization, we tested three hypotheses using the same specimens: (1) collagen fiber orientation is regionally dependent; (2) remodeling changes collagen fiber orientation; (3) longitudinal collagen fibers correlate positively with modulus and monotonic bending strength and negatively with flexural fatigue life. Beams (N = 36) cut parallel to the long axes of six pairs of bones had been tested to determine elastic modulus (N = 36), and fatigue life (N= 24) or monotonic strength (N = 12) in four-point bending. Subsequently, histologic cross-sections were prepared, and porosity, active remodeling and past remodeling were quantified. Birefringence was measured as an indicator of transverse collagen orientation using plane-polarized light (PPL), and again using circularly polarized light (CPL). The CPL measurement was less variable than the PPL measurement. Both birefringence measures indicated that collagen was more longitudinally oriented in the lateral cortex than in the other two cortices. Longitudinally disposed collagen correlated with greater modulus and monotonic strength, but did not correlate with fatigue life. Remodeling was associated with more transverse collagen. Neither measure of birefringence was significantly correlated with porosity. It was concluded that, in the equine cannon bone, longitudinal collage fiber orientation is regionally variable, contributes to increased modulus and strength but not fatigue life, and is reduced by osteonal remodeling.
我们研究了双折射,将其作为马第三掌骨骨干中胶原纤维取向的一个指标。我们之前已经表明,这块骨头外侧皮质的组织比内侧和背侧区域的组织在单调性上更强,但抗疲劳性较差。为了了解胶原纤维取向是否可能在这种区域特化中发挥作用,我们使用相同的标本测试了三个假设:(1)胶原纤维取向具有区域依赖性;(2)重塑会改变胶原纤维取向;(3)纵向胶原纤维与模量和单调弯曲强度呈正相关,与弯曲疲劳寿命呈负相关。平行于六对骨头的长轴切割的梁(N = 36)已经进行了测试,以确定弹性模量(N = 36)、疲劳寿命(N = 24)或四点弯曲中的单调强度(N = 12)。随后,制备了组织学横截面,并对孔隙率、活跃重塑和既往重塑进行了量化。使用平面偏振光(PPL)测量双折射,作为横向胶原取向的指标,然后再次使用圆偏振光(CPL)进行测量。CPL测量的变异性比PPL测量小。两种双折射测量都表明,外侧皮质中的胶原比其他两个皮质中的胶原更倾向于纵向排列。纵向排列的胶原与更大的模量和单调强度相关,但与疲劳寿命无关。重塑与更多横向胶原有关。双折射的两种测量都与孔隙率没有显著相关性。得出的结论是,在马的管骨中,纵向胶原纤维取向在区域上是可变的,有助于增加模量和强度,但与疲劳寿命无关,并且会因骨单位重塑而减少。