Zijlstra G M, Michielsen M J, de Gooijer C D, van der Pol L A, Tramper J
Bio-Intermediair Europe B.V., Groningen, The Netherlands.
Bioseparation. 1996;6(4):201-10.
The partitioning of IgG in aqueous two-phase systems (ATPSs) of PEG and Dextran was studied systematically using a statistical experimental design. Aim was to improve the separation of hybridoma cells and their IgG product, by identifying the key variables governing IgG partitioning, and by comparing the IgG partitioning data with the hybridoma cell partitioning data obtained in previous work. The influence of five factors, i.e. the poly(ethylene glycol) molecular weight (PEG Mw), dextran molecular weight (Dx Mw), tie-line length (TLL), pH and potassium phosphate fraction (KPi/(KPi+KCl)), on IgG partitioning was characterized using a full-factorial experimental design. In all of the ATPS's the IgG partitioned predominantly into the lower phase. The partition coefficient varied between 0.78 (Variable settings: PEG Mw = 6000, Dx Mw = 500000, TLL = 0.10 g g-1, KPi/(KPi+KCl) = 1.0 and pH = 7.4) and 0.0002 (Variable settings: PEG Mw = 35000, Dx Mw = 40000, TLL = 0.20 g g-1 KPi/(KPi+KCl) = 1.0 and pH 6.6). The tie-line length, the dextran molecular weight and the PEG molecular weight had the most pronounced effect on IgG partitioning. Matching the partitioning data of the IgG product with previously obtained data of the hybridoma cell partitioning, showed that within the experimental design no ATPS could be found giving a good separation of the hybridoma cells and their IgG product. There are, however, ATPS's available in which the cells partition to, and grow in the lower dextran-rich phase. To achieve a good separation of the hybridoma cells and their IgG product in these ATPSs, the IgG product has to be specifically extracted into the PEG-rich top phase. For this purpose the use affinity ligands coupled to PEG may offer a solution. Therefore, a number of commercially available dye-resins was screened for their ability to bind the BIF6A7 IgG antibody. The mimetic green 1 A6XL dye-resin was found to bind BIF6A7 IgG. The dye-ligand coupled to PEG was used to manipulate the IgG partitioning in an ATPS. In the presence of the PEG-ligand, the IgG partitioned almost completely to the top phase. The IgG-partition coefficient increased three orders of magnitude, resulting in a 25-fold higher IgG concentration in the top phase than in the bottom phase.
采用统计实验设计系统研究了聚乙二醇(PEG)和葡聚糖组成的双水相体系(ATPSs)中IgG的分配情况。目的是通过确定控制IgG分配的关键变量,并将IgG分配数据与之前工作中获得的杂交瘤细胞分配数据进行比较,来改进杂交瘤细胞及其IgG产物的分离。使用全因子实验设计表征了五个因素,即聚乙二醇分子量(PEG Mw)、葡聚糖分子量(Dx Mw)、系线长度(TLL)、pH值和磷酸钾分数(KPi/(KPi+KCl))对IgG分配的影响。在所有的双水相体系中,IgG主要分配到下相中。分配系数在0.78(变量设置:PEG Mw = 6000,Dx Mw = 500000,TLL = 0.10 g g-1,KPi/(KPi+KCl) = 1.0且pH = 7.4)和0.0002(变量设置:PEG Mw = 35,000, Dx Mw = 40,000,TLL = 0.20 g g-1,KPi/(KPi+KCl) = 1.0且pH 6.6)之间变化。系线长度、葡聚糖分子量和聚乙二醇分子量对IgG分配的影响最为显著。将IgG产物的分配数据与之前获得的杂交瘤细胞分配数据进行匹配,结果表明在实验设计范围内,未发现能实现杂交瘤细胞及其IgG产物良好分离的双水相体系。然而,存在一些双水相体系,细胞会分配到富含葡聚糖的下相中并在其中生长。为了在这些双水相体系中实现杂交瘤细胞及其IgG产物的良好分离,必须将IgG产物特异性提取到富含PEG的上相中。为此,使用与PEG偶联的亲和配体可能提供一种解决方案。因此,筛选了多种市售染料树脂结合BIF6A7 IgG抗体的能力。发现模拟绿1 A6XL染料树脂能结合BIF6A7 IgG。将与PEG偶联的染料配体用于操控双水相体系中IgG的分配。在PEG配体存在的情况下,IgG几乎完全分配到上相中。IgG分配系数增加了三个数量级,导致上相中IgG浓度比下相中高25倍。