Suppr超能文献

用于骶髂螺钉置入的第一骶椎椎弓根的形态学考量

Morphologic considerations of the first sacral pedicle for iliosacral screw placement.

作者信息

Ebraheim N A, Xu R, Biyani A, Nadaud M C

机构信息

Department of Orthopaedic Surgery, Medical College of Ohio, Toledo, USA.

出版信息

Spine (Phila Pa 1976). 1997 Apr 15;22(8):841-6. doi: 10.1097/00007632-199704150-00002.

Abstract

STUDY DESIGN

Morphometric, radiographic, and computed tomographic evaluation of the pedicle of the first sacral vertebra was performed, and the pedicle's spatial relation with the posterior surface of the ilium was defined.

OBJECTIVES

To facilitate accurate localization of the entry site of the iliosacral pedicular screw on the posterior surface of the ilium, to provide optimal length and direction of iliosacral screw placement, and to investigate the feasibility of inserting two screws through the first sacral vertebral pedicle for unstable posterior pelvic fixation.

METHODS

Anterior and posterior pedicular height, pedicular depth, alar depth, and posterior alar height of S1 vertebrae were measured in 11 body pelves bilaterally. Sacral pedicular height was also measured on the outlet view radiograph as visualized during intraoperative fluoroscopy, and compared with actual anatomic pedicular height. The distance from the posterior limit of the ilium to the S1 ala, pedicle, and pedicle axis, and the distance between the outer table of the ilium and anterior cortex of the sacrum were measured on axial computed tomography scans. Finally, parasagittal sections of the sacral were made to assess the safety zone for placement of two pedicular screws into the vertebral body.

RESULTS

The mean anterior and posterior pedicular heights were 30.2 and 26.1 mm, respectively. The depths of the pedicle and ala were 27.8 and 45.8 mm, respectively. The mean posterior alar height was 28.7 mm. The mean first sacral pedicular height measured on the outlet-view radiographs was 20 mm, which was significantly less (P < 0.0001) than the actual gross anatomic pedicular height. The mean distance from the posterior limit of the ilium to the pedicle axis projection point on axial computed tomography scans was 32.5 mm, and the mean distance from this point to the greater sciatic notch was 38.6 mm. The mean distance between the outer table of the ilium and the anterior cortex of the sacrum was 105.2 mm. The safety margin for two closely inserted pedicular screws was only 4 to 6 mm.

CONCLUSIONS

This study suggests that placement of one screw through the S1 pedicle into the vertebral body is safer, and routine placement of two sacral pedicular screws may be difficult. The optimal starting point for placement of single iliosacral screw is 3 to 3.5 cm anterior to the posterior border of the iliac bone in the sagittal plans, and 3.5 to 4 cm cephalad to the greater sciatic notch. The screw should be directed perpendicular to the outer surface of the table from this entry point. The safe length of the iliosacral pedicular screw is up to 80 mm.

摘要

研究设计

对第一骶椎椎弓根进行形态测量、影像学及计算机断层扫描评估,并确定椎弓根与髂骨后表面的空间关系。

目的

便于准确确定髂骶椎弓根螺钉在髂骨后表面的进针点,提供髂骶螺钉置入的最佳长度和方向,并探讨经第一骶椎椎弓根置入两枚螺钉用于不稳定骨盆后环固定的可行性。

方法

对11具尸体骨盆的双侧S1椎体的椎弓根前后高度、椎弓根深度、翼部深度及后翼高度进行测量。在术中透视下观察出口位X线片上的骶椎弓根高度,并与实际解剖学椎弓根高度进行比较。在轴向计算机断层扫描上测量从髂骨后缘至S1翼、椎弓根及椎弓根轴线的距离,以及髂骨外板与骶骨前皮质之间的距离。最后,制作骶骨矢状面切片以评估向椎体置入两枚椎弓根螺钉的安全区域。

结果

椎弓根前后平均高度分别为30.2mm和26.1mm。椎弓根和翼部的深度分别为27.8mm和45.8mm。后翼平均高度为28.7mm。出口位X线片上测得的第一骶椎椎弓根平均高度为20mm,明显低于(P < 0.0001)实际大体解剖学椎弓根高度。轴向计算机断层扫描上从髂骨后缘至椎弓根轴线投影点的平均距离为32.5mm,从该点至坐骨大切迹的平均距离为38.6mm。髂骨外板与骶骨前皮质之间的平均距离为105.2mm。紧密置入的两枚椎弓根螺钉的安全间距仅为4至6mm。

结论

本研究提示,经S1椎弓根向椎体置入一枚螺钉更安全,常规置入两枚骶椎弓根螺钉可能困难。在矢状面上,单枚髂骶螺钉置入最佳起始点位于髂骨后缘前方3至3.5cm,坐骨大切迹上方3.5至4cm。螺钉应从此进针点垂直于髂骨外表面置入。髂骶椎弓根螺钉的安全长度可达80mm。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验