Batinić-Haberle I, Liochev S I, Spasojević I, Fridovich I
Department of Biochemistry, Duke University Medical Center, Durham, North Carolina 27710, USA.
Arch Biochem Biophys. 1997 Jul 15;343(2):225-33. doi: 10.1006/abbi.1997.0157.
Variously modified metalloporphyrins offer a promising route to stable and active mimics of superoxide dismutase (SOD). Here we explore bromination on the pyrroles as a means of increasing the redox potentials and the catalytic activities of the copper and manganese complexes of a cationic porphyrin. Mn(II) and Cu(II) octabrominated 5,10,15,20-tetrakis-(N-methylpyridinium-4-yl) porphyrin, Mn(II)OBTMPyP4+, and Cu(II)OBTMPyP4+ were prepared and characterized. The rate constants for the porphyrin-catalyzed dismutation of O2.- as determined from the inhibition of the cytochrome c reduction are k(cat) = 2.2 x 10(8) and 2.9 x 10(6) M(-1) s(-1), i.e., IC50 was calculated to be 12 nM and 0.88 microM, respectively. The metal-centered half-wave potential was E(1/2) = +0.48 V vs NHE for the manganese compound. Cu(II)OBTMPyP4+ proved to be extremely stable, while its Mn(II) analog has a moderate stability, log K = 8.08. Nevertheless, slow manganese dissociation from Mn(II)OBTMPyP4+ enabled the complex to persist and exhibit catalytic activity even at the nanomolar concentration level and at biological pH. The corresponding Mn(III)OBTMPyP5+ complex exhibited significantly increased stability, i.e., demetallation was not detected in the presence of a 400-fold molar excess of EDTA at micromolar porphyrin concentration and at pH 7.8. The beta-substituted manganese porphyrin facilitated the growth of a SOD-deficient strain of Escherichia coli when present at 0.05 microM but was toxic at 1.0 microM. The synthetic approach used in the case of manganese and copper compounds offers numerous possibilities whereby the interplay of the type and of the number of beta substituents on the porphyrin ring would hopefully lead to porphyrin compounds of increased stability, catalytic activity, and decreased toxicity.
各种经过修饰的金属卟啉为制备稳定且具有活性的超氧化物歧化酶(SOD)模拟物提供了一条有前景的途径。在此,我们探索在吡咯上进行溴化,以此作为提高阳离子卟啉的铜和锰配合物的氧化还原电位及催化活性的一种方法。制备并表征了八溴化的5,10,15,20 - 四(N - 甲基吡啶 - 4 - 基)卟啉的锰(II)和铜(II)配合物,即Mn(II)OBTMPyP4 +和Cu(II)OBTMPyP4 +。由细胞色素c还原抑制测定得到的卟啉催化超氧阴离子歧化的速率常数分别为k(cat)= 2.2×10(8)和2.9×10(6)M(-1)s(-1),即计算得出的IC50分别为12 nM和0.88 μM。对于锰化合物,以标准氢电极(NHE)为参比,其以金属为中心的半波电位为E(1/2)= +0.48 V。事实证明Cu(II)OBTMPyP4 +极其稳定,而其锰(II)类似物具有中等稳定性,log K = 8.08。然而,Mn(II)OBTMPyP4 +中锰的缓慢解离使得该配合物即使在纳摩尔浓度水平和生理pH值下仍能持续存在并表现出催化活性。相应的Mn(III)OBTMPyP5 +配合物表现出显著提高的稳定性,即在微摩尔卟啉浓度和pH 7.8条件下,当存在400倍摩尔过量的EDTA时未检测到脱金属现象。当β - 取代的锰卟啉浓度为0.05 μM时,可促进超氧化物歧化酶缺陷型大肠杆菌菌株的生长,但在浓度为1.0 μM时具有毒性。用于锰和铜化合物的合成方法提供了众多可能性,卟啉环上β取代基的类型和数量之间的相互作用有望产生稳定性增加、催化活性提高且毒性降低的卟啉化合物。