Suppr超能文献

射精和采精后种公马精液样本的精子头部形态测量分析。

Sperm head morphometry analysis of ejaculate and dismount stallion semen samples.

作者信息

Gravance C G, Champion Z, Liu I K, Casey P J

机构信息

Department of Obstetrics and Gynaecology, University of Auckland, New Zealand.

出版信息

Anim Reprod Sci. 1997 May;47(1-2):149-55. doi: 10.1016/s0378-4320(96)01634-x.

Abstract

The evaluation of seminal characteristics is important in the clinical detection of stallion subfertility. Conventional semen evaluation includes subjective determination of sperm concentration, motility, and gross morphology. Due to the subjectivity and variability of the manual morphology assessment, computer automated sperm morphology analyses has been developed. Computer automated sperm morphology analysis was applied in the current study to determine if the morphometric measurements of sperm heads from collected and dismount samples of the same ejaculate were similar. If the post-ejaculate dismount sample is representative of the entire ejaculate, this sample may be utilised in determining the fertility of the ejaculate. Ejaculate samples were collected from ten stallions using an artificial vagina. Post-ejaculate dismount samples of the same ejaculate were taken from the head of the penis. A thin smear of the collected and dismount samples were prepared onto microscope slides and spermatozoa were stained for 40 min in haematoxylin. At least 200 properly digitised sperm heads from each slide were analysed using computer automated sperm morphometry analysis. The mean values for length, width, width/length, area, and perimeter were recorded from each analysis of collected and dismount samples and compared by paired t-test. The coefficients of variation of each analysis was also recorded and compared between collected and dismount samples by paired t-test. No significant differences (P > 0.10) in any measurements were found between collected and dismount samples. The mean values for all stallions for collected and dismount samples were length = 5.96 microM and 6.06 microM, width = 2.95 microM and 2.98 microM, width/length = 0.49 and 0.49, area = 13.31 microM2 and 13.65 microM2 and perimeter = 15.54 microM and 15.74 microM respectively. No significant differences were detected in the coefficients of variation of sperm head measurements from collected and dismount samples. These results indicate sperm head measurements from dismount semen are representative of those of the ejaculate. Hence, sperm head measurements of dismount samples may be viably applied to studies of fertility or in case of clinical fertility assessment. This finding will further assist in the development of normal sperm head morphometry criteria in the stallion. Clinically, a slide can be prepared in the field after natural services matings and analysed accurately and objectively by ASMA.

摘要

种马生育力低下的临床检测中,精液特征评估至关重要。传统的精液评估包括对精子浓度、活力和大体形态的主观判定。由于手工形态学评估存在主观性和变异性,因此已开发出计算机自动精子形态分析技术。本研究应用计算机自动精子形态分析技术,以确定同一射精采集样本和采精后阴茎头样本中精子头部的形态测量值是否相似。如果采精后阴茎头样本能代表整个射精,那么该样本可用于确定射精的生育力。使用人工阴道从10匹种马采集射精样本。从阴茎头部采集同一射精的采精后阴茎头样本。将采集样本和阴茎头样本制成薄涂片置于显微镜载玻片上,精子用苏木精染色40分钟。使用计算机自动精子形态测量分析技术,对每张载玻片上至少200个数字化良好的精子头部进行分析。记录每次采集样本和阴茎头样本分析的长度、宽度、宽长比、面积和周长的平均值,并通过配对t检验进行比较。还记录每次分析的变异系数,并通过配对t检验比较采集样本和阴茎头样本之间的变异系数。采集样本和阴茎头样本在任何测量中均未发现显著差异(P>0.10)。所有种马采集样本和阴茎头样本的平均值分别为:长度=5.96微米和6.06微米,宽度=2.95微米和2.98微米,宽长比=0.49和0.49,面积=13.31平方微米和13.65平方微米,周长=15.54微米和15.74微米。采集样本和阴茎头样本的精子头部测量变异系数未检测到显著差异。这些结果表明,采精后精液中精子头部测量值可代表射精样本的测量值。因此,阴茎头样本的精子头部测量值可有效地应用于生育力研究或临床生育力评估。这一发现将进一步有助于制定种马正常精子头部形态测量标准。临床上,自然交配后可在现场制备载玻片,并通过自动精子形态分析(ASMA)进行准确客观的分析。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验