Kahn J D, Crothers D M
Department of Chemistry, Yale University, New Haven CT 06511, USA.
J Mol Biol. 1998 Feb 13;276(1):287-309. doi: 10.1006/jmbi.1997.1515.
A Monte Carlo simulation method for studying DNA cyclization (or ring-closure) has been extended to the case of protein-induced bending, and its application to experimental data has been demonstrated. Estimates for the geometric parameters describing the DNA bend induced by the catabolite activator protein (CAP or CRP) were obtained which correctly predict experimental DNA cyclization probabilities (J factors), determined for a set of 11 150 to 166 bp DNA restriction fragments bearing A tracts phased against CAP binding sites. We find that simulation of out-of-phase molecules is difficult and time consuming, requiring the geometric parameters to be optimized individually rather than globally. A wedge angle model for DNA bending was found to make reasonable predictions for the free DNA. The bend angle in the CAP-DNA complex is estimated to be 85 to 90 degrees, in agreement with estimates from gel electrophoresis and X-ray co-crystal structures. Since the DNA is found to have a pre-existing bend of 15 degrees, the change in bend angle induced by CAP is 70 to 75 degrees, in a agreement with an estimate from topological measurements. We find evidence for slight (approximately 10 degrees) unwinding by CAP. The persistence length and helical repeat of the unbound portion of the DNA are in accord with literature-cited values, but the best-fit DNA torsional modulus C is found to be 1.7 (+/- 0.2) x 10(-19) erg. cm, versus literature estimates and best-fit values for the free DNA of 2.0 x 10(-19) to 3.4 x 10(-19) erg.com. Simulations using this low value of C predict that cyclization of molecules with out-of-phase bends proceeds via undertwisting or overtwisting of the DNA between the bends, so as to align the bends, rather than through conformations with substantial writhe. We present experiments on the topoisomers formed by cyclization with CAP which support this conclusion, and thereby rationalize the surprising result that cyclization can actually be enhanced by out-of-phase bends if the twist required to align the bends improves the torsional alignment of the ends. The relationship between the present work and previous studies on DNA bending by CAP is discussed, and recommendations are given for the efficient application of the cyclization/simulation approach to DNA bending.
一种用于研究DNA环化(或闭环)的蒙特卡罗模拟方法已扩展到蛋白质诱导弯曲的情况,并证明了其在实验数据中的应用。获得了描述由分解代谢物激活蛋白(CAP或CRP)诱导的DNA弯曲的几何参数估计值,这些估计值正确地预测了实验性DNA环化概率(J因子),该概率是针对一组11个150至166 bp的带有与CAP结合位点相位匹配的A序列的DNA限制性片段测定的。我们发现对异相分子的模拟既困难又耗时,需要分别而非全局地优化几何参数。发现一种用于DNA弯曲的楔角模型对游离DNA能做出合理预测。CAP-DNA复合物中的弯曲角度估计为85至90度,这与凝胶电泳和X射线共晶体结构的估计一致。由于发现DNA预先存在15度的弯曲,所以由CAP诱导的弯曲角度变化为70至75度,这与拓扑测量的估计一致。我们发现有证据表明CAP会导致轻微(约10度)的解旋。DNA未结合部分的持续长度和螺旋重复与文献引用值一致,但发现最佳拟合的DNA扭转模量C为1.7(±0.2)×10⁻¹⁹尔格·厘米,而游离DNA的文献估计值和最佳拟合值为2.0×10⁻¹⁹至3.4×10⁻¹⁹尔格·厘米。使用这个较低的C值进行模拟预测,具有异相弯曲的分子的环化是通过弯曲之间的DNA欠扭转或过扭转来进行的,以便使弯曲对齐,而不是通过具有大量缠绕的构象。我们展示了用CAP环化形成的拓扑异构体的实验,这些实验支持了这一结论,从而解释了一个令人惊讶的结果:如果对齐弯曲所需的扭转改善了末端的扭转对齐,异相弯曲实际上可以增强环化。讨论了当前工作与先前关于CAP诱导DNA弯曲的研究之间的关系,并给出了将环化/模拟方法有效应用于DNA弯曲的建议。