Johnson S K, Bhattacharyya S, Griep M A
Department of Chemistry, Center for Biotechnology, University of Nebraska-Lincoln, Lincoln, Nebraska 68588-0304, USA.
Biochemistry. 2000 Feb 1;39(4):736-44. doi: 10.1021/bi991554l.
DnaB helicase stimulated the second-order RNA primer synthesis activity of primase by over 5000-fold on DNA templates that were 23 nucleotides long. This template length is the same as the DnaB helicase thermodynamic binding site size [Jezewska, M. J., and Bujalowski, W. (1996) Biochemistry 35, 2117-2128]. This phenomenal stimulation was achieved by increasing the template affinity of primase by over 300-fold and increasing the catalytic rate by over 15-fold. It was necessary to determine the optimal amount of DnaB helicase to achieve this stimulation because helicase stimulation was cooperative at low concentration and inhibitory at high helicase concentration. The cooperative stimulation at low concentration indicated the presence of a time-dependent assembly step that preceded the active state. Besides stimulating primase activity, DnaB helicase also prevented primase from synthesizing RNA primers that were longer than the template sequence. In the absence of DnaB helicase, the majority of primers synthesized by primase were longer than the template and were named "overlong primers" [Swart, J. R., and Griep, M. A. (1995) Biochemistry 34, 16097-16106]. In contrast, the helicase-stimulated RNA primers were from 10 to 14 nucleotides in length with the 12-mer representing the majority of the total RNA primers produced. It was shown that DnaB helicase stabilized the open or single-stranded conformation of the template, which favored the synthesis of the template-length-dependent primers. In contrast, when primase acted alone, it stabilized the 3'-end hairpin conformation of the template so that the template's 3'-hydroxyl served as a "DNA primer" from which primase elongated to create the overlong primers.
DnaB解旋酶在23个核苷酸长的DNA模板上,将引发酶的二级RNA引物合成活性提高了5000多倍。这个模板长度与DnaB解旋酶的热力学结合位点大小相同[Jezewska, M. J., and Bujalowski, W. (1996) Biochemistry 35, 2117 - 2128]。这种显著的刺激是通过将引发酶与模板的亲和力提高300多倍以及将催化速率提高15倍以上来实现的。确定实现这种刺激所需的DnaB解旋酶的最佳量很有必要,因为在低浓度下解旋酶的刺激是协同的,而在高解旋酶浓度下是抑制的。低浓度下的协同刺激表明在活性状态之前存在一个时间依赖性的组装步骤。除了刺激引发酶活性外,DnaB解旋酶还能防止引发酶合成比模板序列更长的RNA引物。在没有DnaB解旋酶的情况下,引发酶合成的大多数引物比模板长,这些引物被称为“超长引物”[Swart, J. R., and Griep, M. A. (1995) Biochemistry 34, 16097 - 16106]。相比之下,解旋酶刺激产生的RNA引物长度为10至14个核苷酸,其中12聚体占总RNA引物的大部分。结果表明,DnaB解旋酶稳定了模板的开放或单链构象,这有利于合成与模板长度相关的引物。相反,当引发酶单独作用时,它稳定了模板的3'端发夹构象,使得模板的3'-羟基作为“DNA引物”,引发酶从此处延伸以产生超长引物。