Bhowmick S, Swanlund D J, Bischof J C
Department of Mechanical Engineering, University of Minnesota, Minneapolis 55455, USA.
J Biomech Eng. 2000 Feb;122(1):51-9. doi: 10.1115/1.429627.
To investigate the potential application of thermal therapy in the treatment of prostate cancer, the effects of supraphysiological temperatures (40-70 degrees C) for clinically relevant time periods (approximately 15 minutes) were experimentally studied on attached Dunning AT-1 rat prostate cancer cells using multiple assays. The membrane and reproductive machinery were the targets of injury selected for this study. In order to assess membrane injury, the leakage of calcein was measured dynamically, and the uptake of PI was measured postheating (1-3 hours). Clonogenicity was used as a measure of injury to the reproductive machinery 7 days post-injury after comparable thermal insults. Experimental results from all three assays show a broad trend of increasing injury with an increase in temperature and time of insult. Membrane injury, as measured by the fluorescent dye assays, does not correlate with clonogenic survival for many of the thermal histories investigated. In particular, the calcein assay at temperatures of < or = 40 degrees C led to measurable injury accumulation (dye leakage), which was considered sublethal, as shown by significant survival for comparable insult in the clonogenic assay. Additionally, the PI uptake assay used to measure injury post-thermal insult shows that membrane injury continues to accumulate after thermal insult at temperatures > or = 50 degrees C and may not always correlate with clonogenicity at hyperthermic temperatures such as 45 degrees C. Last, although the clonogenic assay yields the most accurate cell survival data, it is difficult to acquire these data at temperatures > or = 50 degrees C because the thermal transients in the experimental setup are significant as compared to the time scale of the experiment. To improve prediction and understanding of thermal injury in this prostate cancer cell line, a first-order rate process model of injury accumulation (the Arrhenius model) was fit to the experimental results. The activation energy (E) obtained using the Arrhenius model for an injury criterion of 30 percent for all three assays revealed that the mechanism of thermal injury measured is likely different for each of the three assays: clonogenics (526.39 kJ/mole), PI (244.8 kJ/mole), and calcein (81.33 kJ/mole). Moreover, the sensitivity of the rate of injury accumulation (d omega/dt) to temperature was highest for the clonogenic assay, lowest for calcein leakage, and intermediate for PI uptake, indicating the strong influence of E value on d omega/dt. Since the clonogenic assay is linked to the ultimate survival of the cell and accounts for all lethal mechanisms of cellular injury, the E and A values obtained from clonogenic study are the best values to apply to predict thermal injury in cells. For higher temperatures (> or = 50 degrees C) indicative of thermal therapies, the results of PI uptake can be used as a conservative estimate of cell death (underprediction). This is useful until better experimental protocols are available to account for thermal transients at high temperature to assess clonogenic ability. These results provide further insights into the mechanisms of thermal injury in single cell systems and may be useful for designing optimal protocols for clinical thermal therapy.
为了研究热疗法在前列腺癌治疗中的潜在应用,使用多种检测方法,对附着的Dunning AT - 1大鼠前列腺癌细胞在临床相关时间段(约15分钟)内超生理温度(40 - 70摄氏度)的影响进行了实验研究。细胞膜和生殖机制是本研究选定的损伤靶点。为了评估细胞膜损伤,动态测量了钙黄绿素的泄漏情况,并在加热后(1 - 3小时)测量了碘化丙啶的摄取量。克隆形成能力被用作衡量在可比热损伤后7天生殖机制损伤的指标。所有三种检测方法的实验结果都显示出随着温度和损伤时间的增加,损伤呈广泛增加的趋势。通过荧光染料检测法测量的细胞膜损伤,对于许多所研究的热暴露情况,与克隆形成存活率并不相关。特别是,在温度≤40摄氏度时的钙黄绿素检测导致了可测量的损伤积累(染料泄漏),这被认为是亚致死性的,如在克隆形成检测中可比损伤后的显著存活率所示。此外,用于测量热损伤后损伤的碘化丙啶摄取检测表明,在温度≥50摄氏度时,热损伤后细胞膜损伤仍在继续积累,并且在高温如45摄氏度时,可能并不总是与克隆形成能力相关。最后,尽管克隆形成检测产生了最准确的细胞存活数据,但在温度≥50摄氏度时很难获得这些数据,因为与实验时间尺度相比,实验装置中的热瞬变很显著。为了改进对该前列腺癌细胞系热损伤的预测和理解,将损伤积累的一级速率过程模型(阿伦尼乌斯模型)拟合到实验结果中。使用阿伦尼乌斯模型针对所有三种检测方法30%的损伤标准获得的活化能(E)表明,所测量的热损伤机制在三种检测方法中可能各不相同:克隆形成能力(526.39千焦/摩尔)、碘化丙啶(244.8千焦/摩尔)和钙黄绿素(81.33千焦/摩尔)。此外,损伤积累速率(dω/dt)对温度的敏感性在克隆形成检测中最高,在钙黄绿素泄漏检测中最低,在碘化丙啶摄取检测中居中,表明E值对dω/dt有很大影响。由于克隆形成检测与细胞的最终存活相关,并考虑了细胞损伤的所有致死机制,从克隆形成研究中获得的E和A值是用于预测细胞热损伤的最佳值。对于指示热疗法的较高温度(≥50摄氏度),碘化丙啶摄取的结果可作为细胞死亡的保守估计(预测不足)。在有更好的实验方案来考虑高温下的热瞬变以评估克隆形成能力之前,这是有用的。这些结果为单细胞系统中的热损伤机制提供了进一步的见解,可能有助于设计临床热疗法的最佳方案。