Carpenter D F, Silverman G J
Appl Environ Microbiol. 1976 Feb;31(2):243-8. doi: 10.1128/aem.31.2.243-248.1976.
The production of enterotoxin A and nuclease by Staphylococcus aureus strain 100 was studied in a 1.0-liter fermentor. The effects of the gas flow rate, pH, and dissolved oxygen were evaluated. Toxin and nuclease secretion occurred under all conditions which permitted growth of the organism. Final yields of toxin and nuclease in cultures grown at constant air flow rates, ranging from 50 to 500 cm3 per min, were higher at successively higher flow rates. An optimum flow rate for either toxin or nuclease production was not observed. When the aeration rate alone or aeration rate and pH were held constant, the dissolved oxygen levels in the culture decreased from the initial 100% level to 0 to 5% 3 to 4 h after inoculation. The O2 demand of the culture then maintained this level for an additional 4 to 5 h. This low dissolved oxygen interval was characterized by rapid growth and extracellular protein production. Controlling the dissolved oxygen at a constant level throughout growth did not increase the final levels of toxin and nuclease above those achieved at the respective constant pH values. Growth under the influence of a constant aeration rate of 500 cm3 per min and a constant pH of 6.5 and 7.0 yielded the highest titers of nuclease (1,550 units/ml) and toxin (10.5 mug/ml) obtained in any of the fermentations conducted in this study. Sparging fermentor cultures with pure oxygen at a rate of 100 cm3 per min yielded growth and extracellular protein levels similar to those achieved at the sparge rate of 500 cm3 of air per min. Controlling the dissolved oxygen at 100% of pure oxygen saturation appeared to inhibit the culture, as the final cultural turbidity as well as the levels of toxin and nuclease were reduced. These data indicate that enterotoxin and nuclease secretions are closely associated with the growth of strain 100. Analyses of the production rates of these components indicated that early log phase was the most efficient production interval in the growth cycle and that this efficiency was increased by pH control at 6.7 to 6.8 and dissolved oxygen control at 10% of air saturation.
在1.0升发酵罐中研究了金黄色葡萄球菌100株产生肠毒素A和核酸酶的情况。评估了气体流速、pH值和溶解氧的影响。在所有允许该生物体生长的条件下都发生了毒素和核酸酶的分泌。在恒定空气流速(每分钟50至500立方厘米)下培养的培养物中,毒素和核酸酶的最终产量随着流速的不断提高而增加。未观察到毒素或核酸酶产生的最佳流速。当单独保持通气速率或通气速率和pH值恒定时,接种后3至4小时,培养物中的溶解氧水平从初始的100%水平降至0至5%。然后培养物的氧气需求在接下来的4至5小时内维持在这个水平。这个低溶解氧间隔的特点是快速生长和细胞外蛋白质产生。在整个生长过程中将溶解氧控制在恒定水平并没有使毒素和核酸酶的最终水平高于在各自恒定pH值下达到的水平。在每分钟500立方厘米的恒定通气速率以及6.5和7.0的恒定pH值影响下生长,产生了本研究中进行的任何发酵中获得的最高核酸酶效价(1550单位/毫升)和毒素效价(10.5微克/毫升)。以每分钟100立方厘米的速率向发酵罐培养物中通入纯氧,产生的生长和细胞外蛋白质水平与每分钟500立方厘米空气的通气速率下达到的水平相似。将溶解氧控制在纯氧饱和度的100%似乎会抑制培养物,因为最终培养物浊度以及毒素和核酸酶水平都降低了。这些数据表明肠毒素和核酸酶的分泌与100株的生长密切相关。对这些成分产生速率的分析表明,对数早期是生长周期中最有效的产生间隔,并且通过将pH值控制在6.7至6.8以及将溶解氧控制在空气饱和度的10%可以提高这种效率。