Carpenter D F, Silverman G J
Appl Microbiol. 1974 Oct;28(4):628-37. doi: 10.1128/am.28.4.628-637.1974.
Enterotoxin B, nuclease, and total exoprotein production by Staphylococcus aureus strain S-6 was studied in a 0.5-liter fermentor system. While these extracellular products were elaborated over a wide range of aeration rates, maximal production occurred within the very narrow range of 125 to 150 cm(3) of air per min. The levels attained at the optimal aeration rate were not increased by maintaining a constant pH, although yield of enterotoxin:cell mass was highest at a constant pH of 7.0. During the growth cycle of the cultures, when aeration rate alone or aeration rate and pH were held constant, the dissolved oxygen (DO) levels, initially set at 100% of saturation, decreased to 5 to 10% 4 to 5 h after inoculation. The oxygen demand of the culture then maintained this level for an additional 4 to 6 h. This interval of low DO was characterized by maximal growth and exoprotein production. When the DO was controlled at a constant value throughout growth (by increasing or decreasing the airflow rate as appropriate), the culture demonstrated different optima for maximal growth and exoprotein production. A constant DO of 100% stimulated growth to extremely high densities, but the accumulation of toxin and nuclease was not observed. On the other hand, maintaining constant DO levels at 50 or 10% raised exoprotein levels higher than those achieved in a culture grown at the optimal aeration rate. Compared to the optimal aeration rate culture, the 10% DO culture yielded 20% more nuclease, 25% more toxin, and 40 to 50% more total exoprotein. These results indicate that it is the DO and not the aeration rate, per se, that is influential in controlling growth, toxin, nuclease, and total exoprotein production.
在一个0.5升的发酵罐系统中研究了金黄色葡萄球菌S-6菌株产生肠毒素B、核酸酶和总外蛋白的情况。虽然这些细胞外产物在很宽的通气速率范围内都能产生,但最大产量出现在每分钟125至150立方厘米空气的非常窄的范围内。即使保持恒定的pH值,在最佳通气速率下达到的水平也不会增加,尽管在pH值恒定为7.0时,肠毒素与细胞质量的产量最高。在培养物的生长周期中,当单独通气速率或通气速率和pH值保持恒定时,最初设定为饱和状态100%的溶解氧(DO)水平在接种后4至5小时降至5%至10%。然后培养物的需氧量在接下来的4至6小时内维持在这个水平。这个低溶解氧间隔的特点是生长和外蛋白产量最大。当在整个生长过程中将溶解氧控制在恒定值(通过适当地增加或减少气流速率)时,培养物在最大生长和外蛋白产生方面表现出不同的最佳条件。恒定的100%溶解氧刺激生长到极高密度,但未观察到毒素和核酸酶的积累。另一方面,将溶解氧水平保持在50%或10%时,外蛋白水平比在最佳通气速率下生长的培养物中达到的水平更高。与最佳通气速率培养物相比,10%溶解氧培养物产生的核酸酶多20%,毒素多25%,总外蛋白多40%至50%。这些结果表明,影响生长、毒素、核酸酶和总外蛋白产生的是溶解氧本身,而不是通气速率。