Suppr超能文献

米曲霉补料分批培养中形态对搅拌强度的依赖性及其对重组蛋白生产的影响。

Dependence of morphology on agitation intensity in fed-batch cultures of Aspergillus oryzae and its implications for recombinant protein production.

作者信息

Amanullah A, Christensen L H, Hansen K, Nienow A W, Thomas C R

机构信息

Centre for Bioprocess Engineering, School of Chemical Engineering, The University of Birmingham, Edgbaston, Birmingham B 15 2TT, UK.

出版信息

Biotechnol Bioeng. 2002 Mar 30;77(7):815-26. doi: 10.1002/bit.10181.

Abstract

We previously reported that, although agitation conditions strongly affected mycelial morphology, such changes did not lead to different levels of recombinant protein production in chemostat cultures of Aspergillus oryzae (Amanullah et al., 1999). To extend this finding to another set of operating conditions, fed-batch fermentations of A. oryzae were conducted at biomass concentrations up to 34 g dry cell weight/L and three agitation speeds (525, 675, and 825 rpm) to give specific power inputs between 1 and 5 kWm(-3). Gas blending was used to control the dissolved oxygen level at 50% of air saturation except at the lowest speed where it fell below 40% after 60-65 h. The effects of agitation intensity on growth, mycelial morphology, hyphal tip activity, and recombinant protein (amyloglucosidase) production in fed-batch cultures were investigated. In the batch phase of the fermentations, biomass concentration, and AMG secretion increased with increasing agitation intensity. If in a run, dissolved oxygen fell below approximately 40% because of inadequate oxygen transfer associated with enhanced viscosity, AMG production ceased. As with the chemostat cultures, even though mycelial morphology was significantly affected by changes in agitation intensity, enzyme titers (AGU/L) under conditions of substrate limited growth and controlled dissolved oxygen of >50% did not follow these changes. Although the measurement of active tips within mycelial clumps was not considered, a dependency of the specific AMG productivity (AGU/g biomass/h) on the percentage of extending tips was found, suggesting that protein secretion may be a bottle-neck in this strain during fed-batch fermentations.

摘要

我们之前报道过,尽管搅拌条件强烈影响菌丝体形态,但在米曲霉的恒化器培养中,这种变化并未导致重组蛋白产生水平的差异(Amanullah等人,1999年)。为了将这一发现扩展到另一组操作条件,在生物量浓度高达34 g干细胞重量/升以及三种搅拌速度(525、675和825转/分钟)下进行了米曲霉的补料分批发酵,以提供1至5 kWm(-3)之间的比功率输入。除了最低速度下在60 - 65小时后溶解氧降至40%以下外,采用气体混合将溶解氧水平控制在空气饱和度的50%。研究了搅拌强度对补料分批培养中生长、菌丝体形态、菌丝尖端活性和重组蛋白(糖化酶)产生的影响。在发酵的分批阶段,生物量浓度和糖化酶分泌随着搅拌强度的增加而增加。如果在一次运行中,由于与粘度增加相关的氧气传递不足,溶解氧降至约40%以下,糖化酶产生就会停止。与恒化器培养一样,尽管搅拌强度的变化显著影响菌丝体形态,但在底物限制生长且溶解氧控制在>50%的条件下,酶活(AGU/升)并未遵循这些变化。尽管未考虑测量菌丝团内的活性尖端,但发现比糖化酶生产率(AGU/克生物量/小时)与延伸尖端的百分比有关,这表明在补料分批发酵过程中,蛋白质分泌可能是该菌株的一个瓶颈。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验