Dong Jian, Uemura Toshimasa, Shirasaki Yoshio, Tateishi Tetsuya
Tissue Engineering Research Center, National Institute of Advanced Industrial Science and Technology, Ibaraki, Japan.
Biomaterials. 2002 Dec;23(23):4493-502. doi: 10.1016/s0142-9612(02)00193-x.
Beta-tricalcium phosphate (TCP) exhibits rapid degradation and weak mechanical properties, which has limited its application as bone graft substitutes, though it has good biocompatibility and osteoconductivity. We hypothesized that a composite of highly pure porous beta-TCP and bone marrow-derived osteoprogenitor cells (BMO) could improve bone formation, and slow down the degradation of beta-TCP. A highly pure porous beta-TCP with 75% porosity was fabricated. The pores averaged 200-400 microm in diameter, with interconnecting paths 100-200 microm. Blocks of beta-TCP 5 mm3 were combined with BMO, and incubated 2 weeks with (+) or without (-) osteogenic medium. They were then implanted into subcutaneous sites of syngeneic rats for 24 weeks. These composites were harvested at different time points. The alkaline phosphatase activity and bone osteocalcin content of the composites (+) were much higher than corresponding values in the composites (-) of the control group (p<0.01). Light microscopy revealed mature bone and lots of blood vessels only in the TCP/BMO composite (+). The amount of newly formed bone increased until week 24. Slow resorptive activity could be found. The mechanical parameters of the composites were much improved over those of dry beta-TCP blocks. These results showed that tissue engineering treatment on incubating the composites of beta-TCP and BMO cells in osteogenic medium results in a good osteogenic activity.
β-磷酸三钙(TCP)虽然具有良好的生物相容性和骨传导性,但其降解速度快且力学性能较弱,这限制了它作为骨移植替代物的应用。我们推测,高纯度多孔β-TCP与骨髓来源的骨祖细胞(BMO)的复合材料可以促进骨形成,并减缓β-TCP的降解。制备了孔隙率为75%的高纯度多孔β-TCP。孔隙平均直径为200 - 400微米,相互连通的通道为100 - 200微米。将5立方毫米的β-TCP块与BMO结合,并在有(+)或无(-)成骨培养基的条件下孵育2周。然后将它们植入同基因大鼠的皮下部位24周。在不同时间点采集这些复合材料。复合材料(+)的碱性磷酸酶活性和骨钙素含量远高于对照组复合材料(-)的相应值(p<0.01)。光学显微镜观察显示,只有在TCP/BMO复合材料(+)中出现了成熟骨和大量血管。新形成的骨量一直增加到第24周。可以发现缓慢的吸收活性。复合材料的力学参数比干燥的β-TCP块有了很大改善。这些结果表明,在成骨培养基中孵育β-TCP和BMO细胞的复合材料进行组织工程处理可产生良好的成骨活性。