Suppr超能文献

靶向凝血酶不同功能域的合成肽的抗血栓形成作用。

Antithrombotic effects of synthetic peptides targeting various functional domains of thrombin.

作者信息

Kelly A B, Maraganore J M, Bourdon P, Hanson S R, Harker L A

机构信息

Department of Medicine, Emory University School of Medicine, Atlanta, GA 30322.

出版信息

Proc Natl Acad Sci U S A. 1992 Jul 1;89(13):6040-4. doi: 10.1073/pnas.89.13.6040.

Abstract

To determine in vivo functional roles for thrombin's structural domains, we have compared the relative antithrombotic and antihemostatic effects of (i) catalytic-site antithrombin peptide, D-Phe-Pro-Arg; (ii) exosite antithrombin peptide, the C-terminal tyrosine-sulfated dodecapeptide of hirudin; and (iii) bifunctional antithrombin peptide, a 20-mer peptide combining catalytic-site antithrombin peptide and exosite antithrombin peptide with a polyglycyl linker. All three peptides inhibited thrombin-mediated platelet aggregation and fibrin formation in vitro. In vivo thrombus formation was measured in real time as 111In-labeled platelet deposition and 125I-labeled fibrin accumulation on thrombogenic segments incorporated into chronic exteriorized arteriovenous access shunts in baboons. Under low flow conditions, the continuous infusion of peptides reduced thrombus formation onto collagen-coated tubing by half at doses (ID50) and corresponding concentrations (IC50) of 800 nmol per kg per min and 400 nmol/ml for catalytic-site antithrombin peptide, greater than 1250 nmol per kg per min and greater than 1500 mumol/ml for exosite antithrombin peptide, and 50 nmol per kg per min and 25 nmol/ml for bifunctional antithrombin peptide. Under arterial flow conditions, systemically administered bifunctional antithrombin peptide decreased thrombus formation in a dose-dependent manner for segments of collagen-coated tubing or prosthetic vascular graft ID50 and IC50 values of 120 nmol per kg per min and 15 nmol/ml; this dose also produced intermediate inhibition of hemostatic function [bleeding time, 21 +/- 3 min vs. 4.5 +/- 0.5 min (baseline values); P less than 0.001; activated partial thromboplastin time, 285 +/- 13 sec vs. 31 +/- 3 sec (baseline), P less than 0.001]. In contrast, thrombus formation onto segments of endarterectomized aorta was potently decreased by bifunctional antithrombin peptide with an ID50 value of 2.4 nmol per kg per min and an IC50 value of 0.75 nmol/ml, a systemic dose that failed to affect hemostasis. Thus, inhibiting both thrombin's catalytic and exosite domains increases antithrombotic potency by several orders of magnitude over the inhibition of either domain alone, particularly at sites of deep arterial injury.

摘要

为了确定凝血酶结构域在体内的功能作用,我们比较了以下三种物质的相对抗血栓形成和抗止血作用:(i)催化位点抗凝血酶肽,D-苯丙氨酸-脯氨酸-精氨酸;(ii)外位点抗凝血酶肽,水蛭素的C末端酪氨酸硫酸化十二肽;(iii)双功能抗凝血酶肽,一种由催化位点抗凝血酶肽和外位点抗凝血酶肽通过聚甘氨酰接头连接而成的20聚体肽。所有这三种肽在体外均能抑制凝血酶介导的血小板聚集和纤维蛋白形成。在狒狒慢性外置动静脉分流术中,通过实时测量111In标记的血小板沉积和125I标记的纤维蛋白在血栓形成段上的积累来检测体内血栓形成情况。在低流量条件下,持续输注这些肽可使胶原蛋白包被的导管上的血栓形成减少一半,催化位点抗凝血酶肽的剂量(ID50)和相应浓度(IC50)分别为800 nmol/kg/min和400 nmol/ml,外位点抗凝血酶肽大于1250 nmol/kg/min和大于1500 μmol/ml,双功能抗凝血酶肽为50 nmol/kg/min和25 nmol/ml。在动脉血流条件下,全身给药的双功能抗凝血酶肽以剂量依赖方式减少胶原蛋白包被的导管段或人工血管移植物上的血栓形成,ID50和IC50值分别为120 nmol/kg/min和15 nmol/ml;该剂量也对止血功能产生中度抑制作用[出血时间,21±3分钟 vs. 4.5±0.5分钟(基线值);P<0.001;活化部分凝血活酶时间,285±13秒 vs. 31±3秒(基线),P<0.001]。相比之下,双功能抗凝血酶肽能有效减少内膜切除主动脉段上的血栓形成,ID50值为2.4 nmol/kg/min,IC50值为0.75 nmol/ml,该全身剂量对止血没有影响。因此,与单独抑制凝血酶的任何一个结构域相比,同时抑制凝血酶的催化结构域和外位点结构域可使抗血栓形成能力提高几个数量级,特别是在深部动脉损伤部位。

相似文献

引用本文的文献

本文引用的文献

5
Effect of heparin on the interaction between thrombin and hirudin.肝素对凝血酶与水蛭素相互作用的影响。
Eur J Biochem. 1987 Dec 1;169(2):373-6. doi: 10.1111/j.1432-1033.1987.tb13622.x.

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验