Yamazaki Takaharu, Watanabe Tetsu, Nakajima Yoshikazu, Sugamoto Kazuomi, Tomita Tetsuya, Yoshikawa Hideki, Tamura Shinichi
Division of Interdisciplinary Image Analysis, Department of Medical Robotics and Image Sciences, Osaka University Graduate School of Medicine, 2-2 Yamadaoka, Suita, Osaka 565-0871, Japan.
IEEE Trans Med Imaging. 2004 May;23(5):602-12. doi: 10.1109/tmi.2004.826051.
Two-dimensional (2-D)/three-dimensional (3-D) registration techniques using single-plane fluoroscopy are highly important for analyzing 3-D kinematics in applications such as total knee arthroplasty (TKA) implants. The accuracy of single-plane fluoroscopy-based techniques in the determination of translation perpendicular to the image plane (depth position), however, is relatively poor because a change in the depth position causes only small changes in the 2-D silhouette. Accuracies achieved in depth position using conventional 2-D/3-D registration techniques are insufficient for clinical applications. Therefore, we propose a technique for improving the accuracy of depth position determination in order to develop a system for analyzing knee kinematics over the full six degrees of freedom (6 DOF) using single-plane fluoroscopy. In preliminary experiments, the behaviors of errors for each free variable were quantified as evaluation curves by examining changes in cost function with variations in the free variable. The evaluation curve for depth position was more jagged, and the curve peak less pointy, compared to the evaluation curves of the other five variables, and the curve was found to behave differently. Depth position is therefore optimized independently of the other variables, using an approximate evaluation curve of depth position prepared after initial registration. Accuracy of the proposed technique was evaluated by computer simulation and in vitro tests, with validation of absolute position and orientation performed for each knee component. In computer simulation tests, root-mean-square error (RMSE) in depth position was improved from 2.6 mm (conventional) to 0.9 mm (proposed), whereas for in vitro tests, RMSE improved from 3.2 mm to 1.4 mm. Accuracy of the estimation of the remaining two translational and three rotational variables was found to be almost the same as that obtained by conventional techniques. Results of in vivo tests are also described in which the possibility of full 6 DOF kinematic analysis of TKA implants is shown.
使用单平面荧光透视的二维(2-D)/三维(3-D)配准技术对于分析全膝关节置换术(TKA)植入物等应用中的三维运动学非常重要。然而,基于单平面荧光透视的技术在确定垂直于图像平面的平移(深度位置)时,准确性相对较差,因为深度位置的变化在二维轮廓中仅引起微小变化。使用传统的二维/三维配准技术在深度位置实现的精度对于临床应用来说是不够的。因此,我们提出一种提高深度位置确定精度的技术,以便开发一种使用单平面荧光透视分析膝关节在全部六个自由度(6自由度)上运动学的系统。在初步实验中,通过检查自由变量变化时成本函数的变化,将每个自由变量的误差行为量化为评估曲线。与其他五个变量的评估曲线相比,深度位置的评估曲线更参差不齐,曲线峰值更不尖锐,并且发现该曲线表现不同。因此,使用初始配准后准备的深度位置近似评估曲线,独立于其他变量对深度位置进行优化。通过计算机模拟和体外测试对所提出技术的准确性进行评估,并对每个膝关节组件进行绝对位置和方向的验证。在计算机模拟测试中,深度位置的均方根误差(RMSE)从2.6毫米(传统)提高到0.9毫米(所提出),而在体外测试中,RMSE从3.2毫米提高到1.4毫米。发现其余两个平移变量和三个旋转变量的估计精度与传统技术获得的精度几乎相同。还描述了体内测试结果,其中显示了对TKA植入物进行全6自由度运动学分析的可能性。