Proseus Timothy E, Boyer John S
College of Marine Studies and College of Agriculture and Natural Resources, University of Delaware, 700 Pilottown Road, Lewes, DE 19958, USA.
Ann Bot. 2005 May;95(6):967-79. doi: 10.1093/aob/mci113. Epub 2005 Mar 10.
Plant growth involves pressure-driven cell enlargement generally accompanied by deposition of new cell wall. New polysaccharides are secreted by the plasma membrane but their subsequent entry into the wall is obscure. Therefore, polysaccharides and gold colloids of various sizes were presented to the inner wall face as though they were secreted by the plasma membrane.
Primary cell walls were isolated from growing internodes of Chara corallina and one end was attached to a glass capillary. Solutions of dextran or suspensions of gold colloids were pushed into the lumen by oil in the capillary. The oil did not enter the wall, and the solution or suspension was pressed against the inner wall face, pressurized at various 'artificial' P (turgor pressure), and polymer or colloid movement through the wall was monitored.
Interstices in the wall matrix had a diameter of about 4.6 nm measured at high P with gold colloids. Small solute (0.8 nm) readily moved through these interstices unaffected by P. Dextrans of 3.5 nm diameter moved faster at higher P while dextran of 9 nm scarcely entered unless high P was present. Dextran of 11 nm did not enter unless P was above a threshold, and dextran of 27 nm did not enter at P as high as 0.5 MPa. The walls filtered the dextrans, which became concentrated against the inner wall face, and most polymer movement occurred after P stabilized and bulk flow ended.
P created a steep gradient in concentration and mechanical force at the inner wall face that moved large polymers into small wall openings apparently by starting a polymer end or deforming the polymer mechanically at the inner wall face. This movement occurred at P generally accepted to extend the walls for growth.
植物生长涉及压力驱动的细胞增大,通常伴随着新细胞壁的沉积。新的多糖由质膜分泌,但其随后进入细胞壁的过程尚不清楚。因此,将各种大小的多糖和金胶体呈现给内壁表面,就好像它们是由质膜分泌的一样。
从轮藻生长的节间分离出初生细胞壁,一端连接到玻璃毛细管上。通过毛细管中的油将葡聚糖溶液或金胶体悬浮液推入管腔。油不会进入细胞壁,溶液或悬浮液被压在内壁表面,在各种“人工”压力(膨压)下加压,并监测聚合物或胶体通过细胞壁的移动。
在高压力下用金胶体测量,细胞壁基质中的间隙直径约为4.6纳米。小溶质(0.8纳米)很容易通过这些间隙,不受压力影响。直径为3.5纳米的葡聚糖在较高压力下移动得更快,而直径为9纳米的葡聚糖除非存在高压力,否则几乎不进入。直径为11纳米的葡聚糖除非压力高于阈值否则不进入,直径为27纳米的葡聚糖在压力高达0.5兆帕时也不进入。细胞壁过滤葡聚糖,使其在内壁表面浓缩,大多数聚合物的移动发生在压力稳定且整体流动结束之后。
压力在内壁表面产生了浓度和机械力的陡峭梯度,显然是通过在内壁表面启动聚合物末端或使聚合物机械变形,将大聚合物移动到小的细胞壁开口中。这种移动发生在通常认为可使细胞壁伸展以实现生长的压力下。