Suppr超能文献

铜锌超氧化物歧化酶的动力学性质与金属含量的关系

Kinetics properties of Cu,Zn-superoxide dismutase as a function of metal content.

作者信息

Michel Erich, Nauser Thomas, Sutter Barbara, Bounds Patricia L, Koppenol Willem H

机构信息

Inorganic Institute, Department of Chemistry and Applied Biosciences, ETH Zurich, Switzerland.

出版信息

Arch Biochem Biophys. 2005 Jul 15;439(2):234-40. doi: 10.1016/j.abb.2005.05.016.

Abstract

The kinetics of bovine Cu,Zn superoxide dismutase were studied by pulse radiolysis. To ensure the absence of catalytically active free copper, commercially obtained holo-superoxide dismutase was demetallated, and the apo-superoxide dismutase concentrations were determined by isothermal titration calorimetry prior to reconstitution with defined amounts of copper and zinc. The catalytic rate constant was determined as a function of ionic strength over the range of 4-154 mM, and of the copper and zinc content. The catalytic rate constant increases with ionic strength up to (1.5 +/- 0.2) x 10(9) M(-1) s(-1) at an ionic strength of 15 mM, and then decreases. At pH 7 and 50 mM ionic strength, k = (1.2 +/- 0.2) x 10(9) M(-1) s(-1), and at a physiologically relevant ionic strength of 150 mM, it is (0.7 +/- 0.1) x 10 (9) M(-1) s(-1). The effect of ionic strength is ascribed to the inhomogeneous electric field generated by the surface charges of superoxide dismutase. The value of the catalytic rate constant at 50 mM is ca. 2-fold smaller than earlier values reported in the literature. The relationship between copper content and the catalytic rate constant shows that addition of more than a stoichiometric amount of copper cannot be masked efficiently by EDTA. The possibility exists that earlier reported values were based on experiments contaminated with trace amounts of copper.

摘要

通过脉冲辐解研究了牛铜锌超氧化物歧化酶的动力学。为确保不存在具有催化活性的游离铜,将市售获得的全酶超氧化物歧化酶进行脱金属处理,并在重新用规定量的铜和锌重构之前,通过等温滴定量热法测定脱辅基超氧化物歧化酶的浓度。测定了催化速率常数与4 - 154 mM范围内离子强度以及铜和锌含量的函数关系。催化速率常数随离子强度增加,在离子强度为15 mM时达到(1.5±0.2)×10⁹ M⁻¹ s⁻¹,然后下降。在pH 7和50 mM离子强度下,k = (1.2±0.2)×10⁹ M⁻¹ s⁻¹,在生理相关离子强度150 mM时为(0.7±0.1)×10⁹ M⁻¹ s⁻¹。离子强度的影响归因于超氧化物歧化酶表面电荷产生的非均匀电场。50 mM时催化速率常数的值约比文献中先前报道的值小2倍左右。铜含量与催化速率常数之间关系表明,添加超过化学计量的铜不能被EDTA有效掩蔽。有可能先前报道的值是基于被痕量铜污染的实验。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验