Ratnayake R K, Semenenko V A, Stewart R D
School of Health Sciences, Purdue University, West Lafayette, IN 47907-2051, USA.
Int J Radiat Biol. 2005 Jun;81(6):421-8. doi: 10.1080/09553000500156577.
Sample preparation procedures for the pulsed-field gel electrophoresis (PFGE) assay usually involve a lysis step at temperatures as high as 50 degrees C. During this warm-lysis procedure, multiply damaged sites containing heat-labile sites (HLS) can be converted into double-strand breaks (DSB). Once formed, these DSB cannot be distinguished from the DSB formed directly by ionizing radiation. This paper develops a method to correct DSB estimates for the effects of HLS in warm-lysis protocols. A first-order repair model is used to predict the number of HLS available for conversion into DSB as a function of the time available for repair before initiating warm-lysis. A mathematical expression is derived to separate prompt DSB from those formed through the artefactual conversion of HLS into DSB. The proposed formalism only requires the specification of two adjustable parameters, both of which can be estimated from measured data. Estimates of prompt DSB yields obtained by correcting warm-lysis data are in good agreement with estimates obtained using cold-lysis protocols, which do not include the effect of HLS. The retrospective analyses of two published datasets suggest that corrections for HLS have a substantial impact on DSB yields within the first 20-30 min after irradiation. Bi-exponential fits to the DSB data for Chinese hamster ovary cells suggest that corrections for HLS reduce the half-time for fast DSB rejoining by about 15%, whereas the half-time for the slow DSB rejoining only decreases by 4%. The total DSB yield and the fraction of fast-rejoining DSB decrease by 24 and 38%, respectively, when the correction is applied. The proposed formalism can be used to characterize trends and uncertainties in DSB rejoining kinetics associated with the artefactual conversion of HLS into DSB. The retrospective application of the methodology to warm-lysis data enhances their relevance and usefulness for studies of DSB rejoining kinetics.
脉冲场凝胶电泳(PFGE)分析的样品制备程序通常包括在高达50摄氏度的温度下进行裂解步骤。在这个温热裂解过程中,含有热不稳定位点(HLS)的多处受损位点可转化为双链断裂(DSB)。一旦形成,这些DSB无法与直接由电离辐射形成的DSB区分开来。本文开发了一种方法,用于校正温热裂解方案中HLS效应导致的DSB估计值。使用一阶修复模型来预测可转化为DSB的HLS数量,该数量是温热裂解开始前可用于修复的时间的函数。推导了一个数学表达式,以将即时DSB与通过HLS人为转化为DSB而形成的DSB区分开来。所提出的形式主义仅需要指定两个可调参数,这两个参数均可从测量数据中估计出来。通过校正温热裂解数据获得的即时DSB产率估计值与使用不包括HLS效应的冷裂解方案获得的估计值高度一致。对两个已发表数据集的回顾性分析表明,对HLS的校正对辐照后最初20 - 30分钟内的DSB产率有重大影响。对中国仓鼠卵巢细胞的DSB数据进行双指数拟合表明,对HLS的校正使快速DSB重新连接的半衰期缩短了约15%,而慢速DSB重新连接的半衰期仅缩短了4%。应用校正后,总DSB产率和快速重新连接DSB的比例分别下降了24%和38%。所提出的形式主义可用于表征与HLS人为转化为DSB相关的DSB重新连接动力学中的趋势和不确定性。将该方法追溯应用于温热裂解数据可增强其对DSB重新连接动力学研究的相关性和实用性。