Bariol Simon V, Stewart Grant D, Tolley David A
Scottish Lithotriptor Centre, Western General Hospital, Edinburgh, UK.
J Endourol. 2005 Nov;19(9):1127-33. doi: 10.1089/end.2005.19.1127.
In open surgery, handling of suture at any position other than the end is discouraged because of evidence that handling deforms and weakens the material. The limited operative field of laparoscopic surgery necessitates repeated instrument handling of suture, and the effect of such handling has not been investigated. We assessed the effect of trauma imposed on various suture materials by laparoscopic needle holders and forceps. Also, the ideal suturing technique (interrupted v continuous) according to the physical characteristics of the suture material and the optimal length for laparoscopic sutures were determined.
Sutures of 2-0 and 3-0 polyglactin 910 and 2-0 poliglecaprone 25 were tested. Controlled damage was inflicted by grasping the suture for 1 second between the jaws of either toothed laparoscopic grasping forceps or a laparoscopic needle holder at a pressure of 45 MPa. Blind physical testing was then performed using a computer-controlled tensile testing system. The length and proportion of suture extension prior to breaking and the tensile strength were measured. Samples of undamaged and controlled damaged specimens, before and after breakage, were examined by scanning electron microscopy (SEM).
The mean percentage extension in the control group was 46.3 mm for 3-0 Monocryl, 26.3 mm for 3-0 Vicryl, and 28.1 mm for 2-0 Vicryl. The mean tensile strengths were 47.9 N, 42.4 N, and 70.4 N for 3-0 Monocryl and 3-0 and 2-0 Vicryl, respectively. The 3-0 Monocryl and 3-0 Vicryl had significantly reduced tensile strength after damage compared with control sutures, whereas 3-0 Vicryl and 2-0 Vicryl had significantly impaired extension. After infliction of controlled damage with laparoscopic needle holders, the percent extension of damaged sutures was significantly less than that of undamaged sutures. Tensile strength was significantly lower for 3-0 Vicryl and 3-0 Monocryl after damage than before. The handling of Monocryl by laparoscopic needle holders and graspers produced punched-out defects and scratch marks, respectively. A number of damaged 2-0 and 3-0 Vicryl samples from the laparoscopic needle holder group showed disruption or unravelling of the braided filaments.
We expect that our results underestimate the potential effect on suture strength and extension inflicted by laparoscopic suturing. The exact length of suture material cannot be recommended from the findings. However, interrupted sutures should be preferred, particularly for long suture lines. In addition, the findings support the use of laparoscopic graspers in preference to needle holders. The combination of a grasper in one hand and needle holder in the other is ideal. Finally, urologists initially embarking on laparoscopic reconstruction must take meticulous care in their suturing technique and, in particular, the number of times and force with which the suture is grasped.
在开放手术中,不鼓励在缝线末端以外的任何位置进行操作,因为有证据表明这种操作会使材料变形并削弱其强度。腹腔镜手术的操作视野有限,需要反复用器械操作缝线,而这种操作的影响尚未得到研究。我们评估了腹腔镜持针器和镊子对各种缝线材料造成的损伤影响。此外,根据缝线材料的物理特性确定了理想的缝合技术(间断缝合与连续缝合)以及腹腔镜缝线的最佳长度。
测试了2-0和3-0聚乙醇酸910缝线以及2-0聚甘醇酯25缝线。通过在带齿的腹腔镜抓取镊子或腹腔镜持针器的钳口之间以45兆帕的压力抓取缝线1秒钟来造成可控损伤。然后使用计算机控制的拉伸测试系统进行盲法物理测试。测量断裂前缝线的伸长长度和比例以及拉伸强度。对未损伤和可控损伤标本在断裂前后的样本进行扫描电子显微镜(SEM)检查。
对照组中,3-0单丝聚乙醇酸缝线的平均伸长百分比为46.3毫米,3-0聚乙醇酸缝线为26.3毫米,2-0聚乙醇酸缝线为28.1毫米。3-0单丝聚乙醇酸缝线、3-0聚乙醇酸缝线和2-0聚乙醇酸缝线的平均拉伸强度分别为47.9牛、42.4牛和70.4牛。与对照缝线相比,3-0单丝聚乙醇酸缝线和3-0聚乙醇酸缝线在损伤后的拉伸强度显著降低,而3-0聚乙醇酸缝线和2-0聚乙醇酸缝线的伸长能力显著受损。在用腹腔镜持针器造成可控损伤后,受损缝线的伸长百分比显著低于未受损缝线。3-0聚乙醇酸缝线和3-0单丝聚乙醇酸缝线损伤后的拉伸强度明显低于损伤前。腹腔镜持针器和抓取器对单丝聚乙醇酸缝线的操作分别产生了穿孔缺陷和划痕。来自腹腔镜持针器组的许多受损2-0和3-0聚乙醇酸缝线样本显示编织细丝断裂或松散。
我们预计我们的结果低估了腹腔镜缝合对缝线强度和伸长的潜在影响。根据这些发现无法推荐确切的缝线材料长度。然而,应首选间断缝合,特别是对于长缝线。此外,这些发现支持优先使用腹腔镜抓取器而非持针器。一手持抓取器另一手持针器的组合是理想的。最后,刚开始进行腹腔镜重建手术的泌尿外科医生在缝合技术上必须格外小心,特别是在抓取缝线的次数和力度方面。