Liu Zifei, Lu Mingming, Birch M Eileen, Keener Tim C, Khang Soon-Jai, Liang Fuyan
Department of Civil and Environmental Engineering, University of Cincinnati, Cincinnati, Ohio 45221, USA.
Environ Sci Technol. 2005 Oct 15;39(20):7840-4. doi: 10.1021/es048373d.
The emissions of diesel particulate matter (DPM) from diesel engines are causing increasing health concerns due to their suspected carcinogenicity, especially the carbonaceous fractions. The total DPM emissions and the organic and elemental carbon (OC and EC) distributions of the DPM depend on many operating factors, such as load, engine design parameters, fuel sulfur content, fuel usage rate, and sampling conditions. Results of previous studies on the OC/EC variations with load for heavy-duty vehicles have been reported, but information is scarce for nonroad diesel generators. There is a clear need to better characterize nonroad DPM emissions, as studies have indicated that DPM emissions from nonroad diesel engines are significantly higher than those from on-road sources. The objective of the study is to provide a detailed account of the OC/EC distributions for a nonroad diesel generator operated with high and low sulfur fuels under different load conditions. DPM emissions were collected using an EPA Method 5 (Determination of Particulate Matter Emissions from Stationary Sources) sampling train. The OC and EC concentrations were quantified by NIOSH Method 5040. DPM concentrations and the relative contributions of OC, EC, and noncarbonaceous materials vary significantly with engine load, fuel sulfur content, and sample collection temperature. The fractions of EC over DPM increase with increasing load from 21% at OkW to 84% at 75 kW for the low sulfur fuel, while those of OC decrease from 62% to 9%. This is consistent with other studies, and the same trends exist regardless of the sulfur content and DPM collection temperature. The fractions of organic compounds range from 77% to 19% for the high sulfur fuel. Noncarbonaceous materials are from 27% to 18% in fraction from high sulfur DPM as opposed to the 17% to 7% in the low sulfur diesel emissions. At lower collection temperatures, more OC and noncarbonaceous materials are observed.
柴油发动机排放的柴油颗粒物(DPM)因其疑似致癌性,尤其是碳质部分,引发了越来越多的健康担忧。DPM的总排放量以及DPM中有机碳和元素碳(OC和EC)的分布取决于许多运行因素,如负荷、发动机设计参数、燃料硫含量、燃料使用率和采样条件。此前已有关于重型车辆OC/EC随负荷变化的研究结果报道,但针对非道路柴油发电机的相关信息却很少。由于研究表明非道路柴油发动机的DPM排放量显著高于道路源,因此显然有必要更好地描述非道路DPM排放特征。本研究的目的是详细说明一台非道路柴油发电机在不同负荷条件下使用高硫和低硫燃料时的OC/EC分布情况。使用美国环境保护局方法5(固定源颗粒物排放的测定)采样系统收集DPM排放物。通过美国国家职业安全与健康研究所方法5040对OC和EC浓度进行定量分析。DPM浓度以及OC、EC和非碳质物质的相对贡献会因发动机负荷、燃料硫含量和样品采集温度而有显著变化。对于低硫燃料,EC在DPM中的占比随负荷增加从0kW时的21%增至75kW时的84%,而OC的占比则从62%降至9%。这与其他研究结果一致,且无论硫含量和DPM采集温度如何,均存在相同趋势。高硫燃料中有机化合物的占比范围为77%至19%。高硫DPM中非碳质物质的占比为27%至18%,而低硫柴油排放中的这一占比为17%至7%。在较低的采集温度下,会观察到更多的OC和非碳质物质。