Willie Commelin Scholten Phytopathological Laboratory, Javalaan 20, 3742 CP Baarn, The Netherlands.
Appl Environ Microbiol. 1989 Jun;55(6):1340-5. doi: 10.1128/aem.55.6.1340-1345.1989.
Different strains of Pseudomonas putida and P. fluorescens isolated from the rhizosphere and phyllosphere were tested for surface activity in droplet cultures on polystyrene. Droplets of 6 of the 12 wild types tested spread over the surface during incubation, and these strains were considered surface active; strains not showing this reaction were considered non-surface active. Similar reactions were observed on pieces of wheat leaves. Supernatants from centrifuged broth cultures behaved like droplets of suspensions in broth; exposure to 100 degrees C destroyed the activity. Average contact angles of the supernatants of surface-active and non-surface-active strains on polystyrene were 24 degrees and 72 degrees , respectively. The minimal surface tension of supernatants of the surface-active strains was about 46 mN/m, whereas that of the non-surface-active strains was 64 mN/m (estimations from Zisman plots). After 6 days of incubation, wheat flag leaves sprayed with a dilute suspension of a surface-active strain of P. putida (WCS 358RR) showed a significant increase in leaf wettability, which was determined by contact angle measurements. Increasing the initial concentration of bacteria and the amount of nutrients in the inoculum sprayed on leaves reduced the contact angles from 138 degrees on leaves treated with antibiotics (control) to 43 degrees on leaves treated with surface-active bacteria. A closely related strain with no surface activity on polystyrene did not affect leaf wettability, although it was present in densities similar to those of the surface-active strain. Nutrients alone could occasionally also increase leaf wettability, apparently by stimulating naturally occurring surface-active bacteria. When estimating densities of Pseudomonas spp. underneath droplets with low contact angles, it appeared that populations on leaves treated with a surface-active strain could vary from about 10 to 10 CFU cm, suggesting that the surface effect may be prolonged after a decline of the population. The possible ecological implications are discussed.
从根际和叶际分离出的不同假单胞菌(Pseudomonas putida 和 P. fluorescens)菌株在聚苯乙烯上的液滴培养中进行表面活性测试。在孵育过程中,测试的 12 种野生型中的 6 种的液滴在表面上扩散,这些菌株被认为具有表面活性;没有表现出这种反应的菌株被认为是非表面活性的。在小麦叶片上也观察到了类似的反应。离心培养液上清液的行为类似于悬浮液在培养液中的液滴;暴露在 100°C 下会破坏其活性。表面活性和非表面活性菌株在聚苯乙烯上的上清液的平均接触角分别为 24°和 72°。表面活性菌株上清液的最小表面张力约为 46 mN/m,而非表面活性菌株的表面张力约为 64 mN/m(从 Zisman 图估计)。经过 6 天的孵育,用表面活性的假单胞菌(WCS 358RR)的稀悬浮液喷洒的小麦旗叶显示出显著增加的叶片润湿性,这通过接触角测量来确定。增加初始细菌浓度和喷洒在叶片上的接种物中的养分含量,将用抗生素处理的叶片(对照)的接触角从 138°降低到用表面活性细菌处理的叶片的 43°。一种与聚苯乙烯无表面活性的密切相关的菌株不会影响叶片润湿性,尽管它的存在密度与表面活性菌株相似。单独的养分偶尔也可以增加叶片的润湿性,显然是通过刺激天然存在的表面活性细菌。当估计低接触角液滴下的假单胞菌(Pseudomonas spp.)的密度时,用表面活性菌株处理的叶片上的种群数量似乎可以从大约 10 到 10 CFU cm 变化,这表明在种群下降后,表面效应可能会延长。讨论了可能的生态影响。