Development and Planning Department, Ebara Corporation, 1-6-27, Khonan, Minato-ku, Tokyo.
Appl Environ Microbiol. 1992 Sep;58(9):2751-7. doi: 10.1128/aem.58.9.2751-2757.1992.
Characteristic sludge ecosystems arising in anaerobic membrane bioreactors of three pilot-scale plants treating low-strength (less than 1 g of biological oxygen demand per liter) sewage or soybean-processing wastewater were examined by analysis of the colony-forming-curves (CFC) obtained by counting colonies at suitable intervals. The wastewaters, containing high amounts of suspended solids (SS) (SS/chemical oxygen demand ratio, 0.51 to 0.80), were treated by using two types of bioreactors: (i) a hydrolyzation reactor for solubilization and acidification of SS in wastewater and (ii) a methane fermentation reactor for producing methane. The colony counts for the two sewage treatment plants continued to increase even after 3 weeks of incubation, whereas those for soybean-processing wastewater reached an approximately constant level within 3 weeks of incubation. The CFCs were analyzed by correlating the rate of colony appearance on roll tubes with the physiological types of bacteria present in the bioreactors. It was found that there were large numbers of slow-colony-forming anaerobic bacteria within the bioreactors and that the viable populations consisted of a few groups with different growth rates. It is considered that the slow-growing colonies appearing after 10 days of incubation were the dominant microflora in the sewage treated by hydrolyzation reactors. In particular, highly concentrated sludge (30.0 g of mixed-liquor volatile SS per liter) retained by the membrane separation module contained a large number of such bacteria. Slow-growing colonies of these bacteria could be counted by using a sludge extract medium prepared from only the supernatant of autoclaved sludge. In addition, the highest colony counts were almost always obtained with the sludge extract medium, meaning that most of the anaerobic bacteria in these sludges have complex nutrient requirements for growth. This report also indicates the usefulness of application of the CFC analysis method to the study of bacterial populations of anaerobic treatment systems.
对处理低浓度(每升生物需氧量低于 1 克)污水或大豆加工废水的三个中试规模工厂的厌氧膜生物反应器中出现的特征性污泥生态系统进行了研究,通过分析适当间隔时间计数的集落形成曲线(CFC)进行研究。这些废水含有大量的悬浮固体(SS)(SS/化学需氧量比为 0.51 至 0.80),使用两种类型的生物反应器进行处理:(i)水解反应器用于废水的 SS 溶解和酸化,(ii)甲烷发酵反应器用于生产甲烷。对于两个污水处理厂,即使在孵育 3 周后,菌落计数仍继续增加,而对于大豆加工废水,在孵育 3 周内达到了约恒定水平。通过将滚管上出现菌落的速率与生物反应器中存在的细菌生理类型相关联来分析 CFC。结果发现,生物反应器中有大量的生长缓慢的厌氧细菌,并且可存活的种群由具有不同生长速率的少数群体组成。可以认为,在水解反应器处理的污水中,孵育 10 天后出现的生长缓慢的菌落是优势微生物区系。特别是,膜分离模块保留的高浓度污泥(每升混合液挥发性 SS 30.0 克)中含有大量此类细菌。使用仅由灭菌污泥的上清液制备的污泥提取物培养基可以计数这些细菌的生长缓慢的菌落。此外,用污泥提取物培养基通常可以获得最高的菌落计数,这意味着这些污泥中的大多数厌氧菌对生长具有复杂的营养需求。本报告还表明,应用 CFC 分析方法研究厌氧处理系统中的细菌种群是有用的。