Jo Ji Hye, Lee Dae Sung, Park Jong Moon
Department of Chemical Engineering, Advanced Environmental Biotechnology Research Center, School of Environmental Science and Engineering, Pohang University of Science and Technology, San 31, Hyoja-dong, Nam-gu, Pohang, Gyeongbuk 790-784, Korea.
Biotechnol Prog. 2006 Mar-Apr;22(2):431-7. doi: 10.1021/bp050258z.
Biological hydrogen production by the green alga Chlamydomonas reinhardtii under sulfur-deprived conditions has attracted great interest due to the fundamental and practical importance of the process. The photosynthetic hydrogen production rate is dependent on various factors such as strain type, nutrient composition, temperature, pH, and light intensity. In this study, physicochemical factors affecting biological hydrogen production by C. reinhardtii were evaluated with response surface methodology (RSM). First, the maximum specific growth rate of the alga associated with simultaneous changes of ammonium, phosphate, and sulfate concentrations in the culture medium were investigated. The optimum conditions were determined as NH(4+) 8.00 mM, PO(4)(3-) 1.11 mM, and SO(4)(2-) 0.79 mM in Tris-acetate-phosphate (TAP) medium. The maximum specific growth rate with the optimum nutrient concentrations was 0.0373 h(-1). Then, the hydrogen production rate of C. reinhardtii under sulfur-deprivation conditions was investigated by simultaneously changing two nutrient concentrations and pH in the medium. The maximum hydrogen production was 2.152 mL of H(2) for a 10-mL culture of alga with density of 6 x 10(6) cells mL(-1) for 96 h under conditions of NH(4)(+) 9.20 mM, PO(4)(3-) 2.09 mM, and pH 7.00. The obtained hydrogen production rate was approximately 1.55 times higher than that with the typical TAP medium under sulfur deficiency.
莱茵衣藻在缺硫条件下进行生物制氢,因其过程具有基础和实际重要性而备受关注。光合产氢速率取决于多种因素,如菌株类型、营养成分、温度、pH值和光照强度。在本研究中,采用响应面法(RSM)评估了影响莱茵衣藻生物制氢的物理化学因素。首先,研究了培养基中铵、磷酸盐和硫酸盐浓度同时变化时藻类的最大比生长速率。在Tris-乙酸盐-磷酸盐(TAP)培养基中,最佳条件确定为NH(4+) 8.00 mM、PO(4)(3-) 1.11 mM和SO(4)(2-) 0.79 mM。最佳营养浓度下的最大比生长速率为0.0373 h(-1)。然后,通过同时改变培养基中的两种营养浓度和pH值,研究了莱茵衣藻在缺硫条件下的产氢速率。在NH(4)(+) 9.20 mM、PO(4)(3-) 2.09 mM和pH 7.00的条件下,对于密度为6×10(6)个细胞mL(-1)的10 mL藻类培养物,96小时内最大产氢量为2.152 mL H(2)。在缺硫条件下,获得的产氢速率比典型的TAP培养基高出约1.55倍。