Kalilani Linda, Atashili Julius
Department of Epidemiology, School of Public Health, University of North Carolina at Chapel Hill, USA.
Epidemiol Perspect Innov. 2006 Apr 18;3:5. doi: 10.1186/1742-5573-3-5.
Interaction measured on the additive scale has been argued to be better correlated with biologic interaction than when measured on the multiplicative scale. Measures of interaction on the additive scale have been developed using risk ratios. However, in studies that use odds ratios as the sole measure of effect, the calculation of these measures of additive interaction is usually performed by directly substituting odds ratios for risk ratios. Yet assessing additive interaction based on replacing risk ratios by odds ratios in formulas that were derived using the former may be erroneous. In this paper, we evaluate the extent to which three measures of additive interaction - the interaction contrast ratio (ICR), the attributable proportion due to interaction (AP), and the synergy index (S), estimated using odds ratios versus using risk ratios differ as the incidence of the outcome of interest increases in the source population and/or as the magnitude of interaction increases. Our analysis shows that the difference between the two depends on the measure of interaction used, the type of interaction present, and the baseline incidence of the outcome. Substituting odds ratios for risk ratios, when calculating measures of additive interaction, may result in misleading conclusions. Of the three measures, AP appears to be the most robust to this direct substitution. Formulas that use stratum specific odds and odds ratios to accurately calculate measures of additive interaction are presented.
有人认为,与以乘法尺度衡量相比,以加法尺度衡量的相互作用与生物相互作用的相关性更好。已使用风险比开发了加法尺度上的相互作用度量。然而,在那些将比值比作为唯一效应度量的研究中,这些加法相互作用度量的计算通常是通过直接用比值比替代风险比来进行的。然而,在使用前者推导的公式中,基于用比值比替代风险比来评估加法相互作用可能是错误的。在本文中,我们评估了三种加法相互作用度量——相互作用对比率(ICR)、归因于相互作用的比例(AP)和协同指数(S),在源人群中感兴趣结局的发生率增加和/或相互作用程度增加时,使用比值比与使用风险比进行估计的差异程度。我们的分析表明,两者之间的差异取决于所使用的相互作用度量、存在的相互作用类型以及结局的基线发生率。在计算加法相互作用度量时,用比值比替代风险比可能会导致误导性结论。在这三种度量中,AP似乎对这种直接替代最为稳健。本文还给出了使用分层特定比值和比值比来准确计算加法相互作用度量的公式。