Suppr超能文献

马来西亚人群颈椎椎弓根直径的计算机断层扫描测量及经椎弓根固定的可行性

Computerized tomographic measurement of the cervical pedicles diameter in a Malaysian population and the feasibility for transpedicular fixation.

作者信息

Yusof Mohd Imran, Ming Liau Kai, Abdullah Mohd Shafie, Yusof Abdul Halim

机构信息

Spine Unit, Department of Orthopaedics, School of Medical Science USM, Kelantan, Malaysia.

出版信息

Spine (Phila Pa 1976). 2006 Apr 15;31(8):E221-4. doi: 10.1097/01.brs.0000210263.87578.65.

Abstract

STUDY DESIGN

The cervical pedicle diameter size differs between Asians and non-Asians. The authors studied the transverse pedicle diameter of the C2-C7 of the cervical spine in a Malaysian population using computerized tomography (CT) measurements. The transverse diameter of the pedicle is the determinant of the feasibility of this technique because the sagittal diameter of the pedicle has been wider than the transverse pedicle diameter.

OBJECTIVES

To study the average transverse pedicle diameter of the cervical spine in a Malaysian population, and evaluate the feasibility and safety of pedicle screw fixation in these patients.

SUMMARY OF BACKGROUND DATA

Cervical transpedicular screw fixation has been safe and is most probably going to be the gold standard for cervical spine fixation. However, its use in the Asian population should be considered cautiously because our cervical pedicle diameter may not be adequate to accommodate the standard pedicle screw size, which can be dangerous because there are vital structures located adjacent to the pedicles.

METHODS

The measurements of the cervical pedicles were performed on CT images using its measurement tools. CT cutting was made at 2.5-mm intervals. The pedicle transverse diameters were defined as the most outer diameter of the pedicle, taken perpendicular to the axis of the pedicle and measured in millimeters up to 0.1 mm.

RESULTS

The mean transverse diameters of the cervical pedicle of C2, C3, C4, C5, C6, and C7 in males were 5.4, 5.2, 5.1, 5.2, 5.5, and 6.5 mm, respectively, and ranged between 5.1 and 6.5 mm. In females, the mean transverse diameter of the cervical pedicle of C2, C3, C4, C5, C6, and C7 were 5.0, 4.6, 4.7, 4.9, 5.2, and 5.6 mm, respectively, and ranged between 4.6 and 5.6 mm. If the minimum transverse diameter required is 5.0 mm for 3.5-mm screw insertion, about 4.2% to 54.2% (male) of pedicles at different levels and 6.7% to 73.3% (females) of patients cannot have fixation with a 3.5-mm screw using this technique.

CONCLUSION

Transpedicular screw fixation for the cervical spine must not be attempted in the Malaysian population before the exact pedicle diameters are known.Therefore, preoperative CT evaluation is a must before transpedicular fixation is performed, especially in female patients. Because the margin for mistake is very narrow, it is best avoided in upper cervical spines.

摘要

研究设计

亚洲人与非亚洲人的颈椎椎弓根直径大小存在差异。作者利用计算机断层扫描(CT)测量方法,对马来西亚人群颈椎C2 - C7的椎弓根横径进行了研究。椎弓根的横径是该技术可行性的决定因素,因为椎弓根的矢状径比椎弓根横径更宽。

目的

研究马来西亚人群颈椎的平均椎弓根横径,并评估这些患者椎弓根螺钉固定的可行性和安全性。

背景数据总结

颈椎经椎弓根螺钉固定一直是安全的,很可能会成为颈椎固定的金标准。然而,在亚洲人群中使用时应谨慎考虑,因为我们的颈椎椎弓根直径可能不足以容纳标准的椎弓根螺钉尺寸,这可能很危险,因为椎弓根附近有重要结构。

方法

使用CT图像的测量工具对颈椎椎弓根进行测量。以2.5毫米的间隔进行CT切割。椎弓根横径定义为椎弓根的最外径,垂直于椎弓根轴线测量,精确到0.1毫米。

结果

男性C2、C3、C4、C5、C6和C7颈椎椎弓根的平均横径分别为5.4、5.2、5.1 mm、5.2、5.5和6.5毫米,范围在5.1至6.5毫米之间。女性C2、C3、C4、C5、C6和C7颈椎椎弓根的平均横径分别为5.0、4.6、4.7、4.9、5.2和5.6毫米,范围在4.6至5.6毫米之间。如果3.5毫米螺钉插入所需的最小横径为5.0毫米,那么采用该技术时,不同节段约4.2%至54.2%(男性)的椎弓根以及6.7%至73.3%(女性)的患者无法使用3.5毫米螺钉进行固定。

结论

在马来西亚人群中,在确切了解椎弓根直径之前,切勿尝试颈椎经椎弓根螺钉固定。因此,在进行经椎弓根固定之前,术前CT评估是必需的,尤其是在女性患者中。由于出错的余地非常小,在上颈椎最好避免使用。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验