da Silva Gabriel, Bozzelli Joseph W
Department of Chemistry and Environmental Science, New Jersey Institute of Technology, Newark, New Jersey 07102, USA.
J Phys Chem A. 2006 Dec 7;110(48):13058-67. doi: 10.1021/jp063772b.
Aldehydes are important intermediates and products in a variety of combustion and gas-phase oxidation processes, such as in low-temperature combustion, in the atmosphere, and in interstellar media. Despite their importance, the enthalpies of formation and bond dissociation energies (BDEs) for the aldehydes are not accurately known. We have determined enthalpies of formation for acetaldehyde, propanal, and butanal from thermodynamic cycles, using experimentally measured reaction and formation enthalpies. All enthalpy values used for reference molecules and reactions were first verified to be accurate to within around 1 kcal mol-1 using high-level ab initio calculations. Enthalpies of formation were found to be -39.72 +/- 0.16 kcal mol-1 for acetaldehyde, -45.18 +/- 1.1 kcal mol-1 for propanal, and -49.27 +/- 0.16 kcal mol-1 for butanal. Enthalpies of formation for these three aldehydes, as well as for pentanal, hexanal, and heptanal, were calculated using the G3, G3B3, and CBS-APNO theoretical methods, in conjunction with bond-isodesmic work reactions. On the basis of the results of our thermodynamic cycles, theoretical calculations using isodesmic work reactions, and existing experimental measurements, we suggest that the best available formation enthalpies for the aldehydes acetaldehyde, propanal, butanal, pentanal, hexanal, and heptanal are -39.72, -45.18, -50.0, -54.61, -59.37, and -64.2 kcal mol-1, respectively. Our calculations also identify that the literature enthalpy of formation of crotonaldehyde is in error by as much as 1 kcal mol-1, and we suggest a value of -25.1 kcal mol-1, which we calculate using isodesmic work reactions. Bond energies for each of the bonds in the aldehydes up to pentanal were calculated at the CBS-APNO level. Analysis of the BDEs reveals the R-CH(2)CH=O to be the weakest bond in all aldehydes larger than acetaldehyde, due to formation of the resonantly stabilized vinoxy radical (vinyloxy radical/formyl methyl radical). It is proposed that the vinoxy radical as well as the more commonly considered formyl and acetyl radicals are important products of aldehyde combustion and oxidation, and the reaction pathways of the vinoxy, formyl, and acetyl radicals are discussed. Group additivity values for the carbon-oxygen-hydrogen groups common to the aldehydes are also determined. Internal rotor profiles and electrostatic potential surfaces are used to study the dipole induced dipole-dipole interaction in the synperiplanar conformation of propanal. It is proposed that the loss of this dipole-dipole interaction in RC(.-)HCH(2)CH=O radicals causes a ca. 1-2 kcal mol-1 decrease in the aldehyde C-H and C-C bond energies corresponding to RC(.-)HCH(2)CH=O radical formation.
醛类是多种燃烧和气相氧化过程中的重要中间体和产物,比如在低温燃烧、大气环境以及星际介质中。尽管醛类很重要,但其生成焓和键解离能(BDEs)尚未得到精确测定。我们通过热力学循环,利用实验测量的反应焓和生成焓,确定了乙醛、丙醛和丁醛的生成焓。用于参考分子和反应的所有焓值首先通过高水平的从头算计算验证,确保精确到约1千卡/摩尔以内。结果发现,乙醛的生成焓为-39.72±0.16千卡/摩尔,丙醛为-45.18±1.1千卡/摩尔,丁醛为-49.27±0.16千卡/摩尔。使用G3、G3B3和CBS-APNO理论方法,并结合键等键反应,计算了这三种醛以及戊醛、己醛和庚醛的生成焓。基于我们的热力学循环结果、使用等键反应的理论计算以及现有的实验测量,我们认为乙醛、丙醛、丁醛、戊醛、己醛和庚醛目前最佳的生成焓分别为-39.72、-45.18、-50.0、-54.61、-59.37和-64.2千卡/摩尔。我们的计算还发现,文献中巴豆醛的生成焓误差高达1千卡/摩尔,我们建议其值为-25.1千卡/摩尔,这是我们通过等键反应计算得出的。在CBS-APNO水平上计算了直至戊醛的醛类中每个键的键能。对键解离能的分析表明,对于所有比乙醛大的醛类,R-CH(2)CH=O是最弱的键,这是由于共振稳定的乙烯氧基自由基(乙烯氧基自由基/甲酰甲基自由基)的形成。有人提出,乙烯氧基自由基以及更常被考虑的甲酰基和乙酰基自由基是醛类燃烧和氧化的重要产物,并讨论了乙烯氧基、甲酰基和乙酰基自由基的反应途径。还确定了醛类中常见的碳-氧-氢基团的基团加和值。利用内转子轮廓和静电势面研究了丙醛顺叠构象中的偶极诱导偶极-偶极相互作用。有人提出,在RC(.-)HCH(2)CH=O自由基中这种偶极-偶极相互作用的丧失导致与RC(.-)HCH(2)CH=O自由基形成相对应的醛类C-H和C-C键能降低约1 - 2千卡/摩尔。