Jabbari Keyvan, Sarfehnia Arman, Podgorsak Ervin B, Seuntjens Jan P
Medical Physics Unit, McGill University, Montreal General Hospital, 1650 avenue Cedar, Montreal, Quebec H3G 1A4, Canada.
Phys Med Biol. 2007 Feb 21;52(4):1171-84. doi: 10.1088/0031-9155/52/4/021. Epub 2007 Jan 30.
The basic characteristics of orthogonal bremsstrahlung beams are studied and the feasibility of improved contrast imaging with such a beam is evaluated. In the context of this work, orthogonal bremsstrahlung beams represent the component of the bremsstrahlung distribution perpendicular to the electron beam impinging on an accelerator target. The BEAMnrc Monte Carlo code was used to study target characteristics, energy spectra and relative fluences of orthogonal beams to optimize target design. The reliability of the simulations was verified by comparing our results with benchmark experiments. Using the results of the Monte Carlo optimization, the targets with various materials and a collimator were designed and built. The primary pencil electron beam from the research port of a Varian Clinac-18 accelerator striking on Al, Pb and C targets was used to create orthogonal beams. For these beams, diagnostic image contrast was tested by placing simple Lucite objects in the path of the beams and comparing image contrast obtained in the orthogonal direction to the one obtained in the forward direction. The simulations for various target materials and various primary electron energies showed that a width of 80% of the continuous-slowing-down approximation range (RCSDA) is sufficient to remove electron contamination in the orthogonal direction. The photon fluence of the orthogonal beam for high Z targets is larger compared to low Z targets, i.e. by a factor of 20 for W compared to Be. For a 6 MeV electron beam, the mean energy for low Z targets is calculated to be 320 keV for Al and 150 keV for Be, and for a high Z target like Pb to be 980 keV. For irradiation times of 1.2 s in an electron mode of the linac, the contrast of diagnostic images created with orthogonal beams from the Al target is superior to that in the forward direction. The image contrast and the beam profile of the bremsstrahlung beams were also studied. Both the Monte Carlo study and experiment showed an improvement of the contrast for lower Z target materials. This study confirms the feasibility, both in terms of intensity and image contrast, of orthogonal bremsstrahlung beams for radiation therapy imaging.
研究了正交轫致辐射束的基本特性,并评估了利用这种束进行改进的对比度成像的可行性。在本工作中,正交轫致辐射束表示轫致辐射分布中垂直于撞击加速器靶的电子束的分量。使用BEAMnrc蒙特卡罗代码研究正交束的靶特性、能谱和相对注量,以优化靶设计。通过将我们的结果与基准实验进行比较,验证了模拟的可靠性。利用蒙特卡罗优化结果,设计并制造了具有不同材料的靶和准直器。使用来自Varian Clinac - 18加速器研究端口的初级笔形电子束撞击铝、铅和碳靶来产生正交束。对于这些束,通过将简单的有机玻璃物体放置在束的路径中,并将在正交方向上获得的图像对比度与在向前方向上获得的图像对比度进行比较,来测试诊断图像对比度。针对各种靶材料和各种初级电子能量的模拟表明,连续慢化近似范围(RCSDA)的80%宽度足以去除正交方向上的电子污染。与低Z靶相比,高Z靶的正交束的光子注量更大,例如钨与铍相比大20倍。对于6 MeV的电子束,计算得出低Z靶中铝的平均能量为320 keV,铍为150 keV,对于像铅这样的高Z靶为980 keV。在直线加速器的电子模式下辐照时间为1.2 s时,由铝靶产生的正交束所创建的诊断图像的对比度优于向前方向的对比度。还研究了轫致辐射束的图像对比度和束轮廓。蒙特卡罗研究和实验均表明,对于较低Z靶材料,对比度有所提高。本研究证实了正交轫致辐射束用于放射治疗成像在强度和图像对比度方面的可行性。