Chung C A, Chen C W, Chen C P, Tseng C S
Department of Mechanical Engineering, National Central University, Jhongli 32001, Taiwan.
Biotechnol Bioeng. 2007 Aug 15;97(6):1603-16. doi: 10.1002/bit.21378.
Perfusion bioreactors improve mass transfer in cell-scaffold constructs. We developed a mathematical model to simulate nutrient flow through cellular constructs. Interactions among cell proliferation, nutrient consumption, and culture medium circulation were investigated. The model incorporated modified Contois cell-growth kinetics that includes effects of nutrient saturation and limited cell growth. Nutrient uptake was depicted through the Michaelis-Menton kinetics. To describe the culture medium convection, the fluid flow outside the cell-scaffold construct was described by the Navier-Stokes equations, while the fluid dynamics within the construct was modeled by Brinkman's equation for porous media flow. Effects of the media perfusion were examined by including time-dependant porosity and permeability changes due to cell growth. The overall cell volume was considered to consist of cells and extracellular matrices (ECM) as a whole without treating ECM separately. Numerical simulations show when cells were cultured subjected to direct perfusion, they penetrated to a greater extent into the scaffold and resulted in a more uniform spatial distribution. The cell amount was increased by perfusion and ultimately approached an asymptotic value as the perfusion rates increased in terms of the dimensionless Peclet number that accounts for the ratio of nutrient perfusion to diffusion. In addition to enhancing the nutrient delivery, perfusion simultaneously imposes flow-mediated shear stress to the engineered cells. Shear stresses were found to increase with cell growth as the scaffold void space was occupied by the cell and ECM volumes. The macro average stresses increased from 0.2 mPa to 1 mPa at a perfusion rate of 20 microm/s with the overall cell volume fraction growing from 0.4 to 0.7, which made the overall permeability value decrease from 1.35 x 10(-2)cm(2) to 5.51 x 10(-4)cm(2). Relating the simulation results with perfusion experiments in literature, the average shear stresses were below the critical value that would induce the chondrocyte necrosis.
灌注生物反应器可改善细胞 - 支架构建物中的传质。我们开发了一个数学模型来模拟营养物质在细胞构建物中的流动。研究了细胞增殖、营养物质消耗和培养基循环之间的相互作用。该模型纳入了修正的康托伊斯细胞生长动力学,其中包括营养物质饱和度和有限细胞生长的影响。营养物质摄取通过米氏动力学来描述。为了描述培养基对流,细胞 - 支架构建物外部的流体流动由纳维 - 斯托克斯方程描述,而构建物内的流体动力学则由用于多孔介质流动的布林克曼方程建模。通过纳入由于细胞生长导致的随时间变化的孔隙率和渗透率变化来研究培养基灌注的影响。整体细胞体积被视为由细胞和细胞外基质(ECM)组成的一个整体,而没有单独处理ECM。数值模拟表明,当细胞在直接灌注条件下培养时,它们在支架中的渗透程度更大,并导致更均匀的空间分布。细胞数量通过灌注增加,并且最终随着灌注速率以考虑营养物质灌注与扩散比率的无量纲佩克莱数增加而接近一个渐近值。除了增强营养物质输送外,灌注同时还对工程细胞施加流动介导的剪切应力。发现剪切应力随着细胞生长而增加,因为支架空隙空间被细胞和ECM体积占据。在灌注速率为20微米/秒时,宏观平均应力从0.2毫帕增加到1毫帕,整体细胞体积分数从0.4增长到0.7,这使得整体渗透率值从1.35×10⁻²平方厘米降低到5.51×10⁻⁴平方厘米。将模拟结果与文献中的灌注实验相关联,平均剪切应力低于会诱导软骨细胞坏死的临界值。