Aryan Henry E, Newman C Benjamin, Nottmeier Eric W, Acosta Frank L, Wang Vincent Y, Ames Christopher P
Department of Neurosurgery, University of California, San Francisco Medical Center, 94143, USA.
J Neurosurg Spine. 2008 Mar;8(3):222-9. doi: 10.3171/SPI/2008/8/3/222.
Stabilization of the atlantoaxial complex has proven to be very challenging. Because of the high mobility of the C1-2 motion segment, fusion rates at this level have been substantially lower than those at the subaxial spine. The set of potential surgical interventions is limited by the anatomy of this region. In 2001 Jürgen Harms described a novel technique for individual fixation of the C-1 lateral mass and the C-2 pedicle by using polyaxial screws and rods. This method has been shown to confer excellent stability in biomechanical studies. Cadaveric and radiographic analyses have indicated that it is safe with respect to osseous and vascular anatomy. Clinical outcome studies and fusion rates have been limited to small case series thus far. The authors reviewed the multicenter experience with 102 patients undergoing C1-2 fusion via the polyaxial screw/rod technique. They also describe a modification to the Harms technique.
One hundred two patients (60 female and 42 male) with an average age of 62 years were included in this analysis. The average follow-up was 16.4 months. Indications for surgery were instability at the C1-2 level, and a chronic Type II odontoid fracture was the most frequent underlying cause. All patients had evidence of instability on flexion and extension studies. All underwent posterior C-1 lateral mass to C-2 pedicle or pars screw fixation, according to the method of Harms. Thirty-nine patients also underwent distraction and placement of an allograft spacer into the C1-2 joint, the authors' modification of the Harms technique. None of the patients had supplemental sublaminar wiring.
All but 2 patients with at least a 12-month follow-up had radiographic evidence of fusion or lack of motion on flexion and extension films. All patients with an allograft spacer demonstrated bridging bone across the joint space on plain x-ray films and computed tomography. The C-2 root was sacrificed bilaterally in all patients. A postoperative wound infection developed in 4 patients and was treated conservatively with antibiotics and local wound care. One patient required surgical debridement of the wound. No patient suffered a neurological injury. Unfavorable anatomy precluded the use of C-2 pedicle screws in 23 patients, and thus, they underwent placement of pars screws instead.
Fusion of C1-2 according to the Harms technique is a safe and effective treatment modality. It is suitable for a wide variety of fracture patterns, congenital abnormalities, or other causes of atlantoaxial instability. Modification of the Harms technique with distraction and placement of an allograft spacer in the joint space may restore C1-2 height and enhance radiographic detection of fusion by demonstrating a graft-bone interface on plain x-ray films, which is easier to visualize than the C1-2 joint.
寰枢复合体的稳定已被证明极具挑战性。由于C1-2运动节段的高活动度,该节段的融合率显著低于下颈椎。这一区域的解剖结构限制了潜在的手术干预方式。2001年,于尔根·哈姆斯描述了一种使用多轴螺钉和棒对C1侧块和C2椎弓根进行个体化固定的新技术。生物力学研究表明该方法具有出色的稳定性。尸体研究和影像学分析表明,就骨与血管解剖结构而言,该方法是安全的。迄今为止,临床疗效研究和融合率仅限于小样本病例系列。作者回顾了102例采用多轴螺钉/棒技术进行C1-2融合的多中心经验。他们还描述了对哈姆斯技术的一种改良。
本分析纳入了102例患者(60例女性,42例男性),平均年龄62岁。平均随访时间为16.4个月。手术指征为C1-2水平不稳定,慢性Ⅱ型齿状突骨折是最常见的潜在病因。所有患者在屈伸位研究中均有不稳定的证据。所有患者均根据哈姆斯方法接受了后路C1侧块至C2椎弓根或椎弓根峡部螺钉固定。39例患者还接受了撑开并在C1-2关节置入同种异体骨间隔物,这是作者对哈姆斯技术的改良。所有患者均未进行补充的椎板下钢丝固定。
除2例随访至少12个月的患者外,所有患者在屈伸位X线片上均有融合或无活动的影像学证据。所有置入同种异体骨间隔物的患者在普通X线片和计算机断层扫描上均显示关节间隙有桥接骨。所有患者双侧C2神经根均被切断。4例患者发生术后伤口感染,经抗生素保守治疗和局部伤口护理。1例患者需要手术清创伤口。无患者发生神经损伤。23例患者因解剖结构不佳无法使用C2椎弓根螺钉,因此改行椎弓根峡部螺钉置入。
根据哈姆斯技术进行C1-2融合是一种安全有效的治疗方式。它适用于多种骨折类型、先天性异常或其他导致寰枢椎不稳定的原因。对哈姆斯技术进行改良,在关节间隙进行撑开并置入同种异体骨间隔物,可恢复C1-2高度,并通过在普通X线片上显示移植骨界面增强融合的影像学检测,该界面比C1-2关节更容易观察到。